STOPPER INSTALLATION PROCEDURE
The Stopper can be installed two ways, “Locked” Mode (Stopper cannot be removed) or “Unlock” Mode (Stopper is removable).
Locked Mode: |
|
Look at the Plastic Loop at the bottom of the Stopper and notice |
|
that the Loop is on one side of the Stopper. Fig. G. | Fig. G. |
| |
To install the stopper in “Locked” mode, insert the Stopper into |
|
the Drain so that the Plastic Loop is facing toward the rear of the |
|
Sink and the American Standard logo is facing front. Rotate | LOGO |
Stopper slightly if necessary so that the Stopper slides all the |
|
way down.Fig. G. |
|
| |
to make sure it is fully inserted. Fig. J. |
|
LOOP TOWARD | |
outward. If the Cam Cap does not “snap” into place, then rotate | REAR OF SINK |
| |
the Cam to make sure it is fully inserted. Fig. K. | DRAIN |
|
Troubling Shooting Guide to complete installation. Stopper will beLocked Mode in “Locked” mode and not be removable.
Unlocked Mode:
Look at the Plastic Loop at the bottom of the Stopper and notice
that the Loop is on one side of the Stopper. Fig. H. | Fig. H. |
To install the stopper in “Unlocked” mode, insert the Stopper into |
|
the Drain so that the Plastic Loop is facing toward the front of the |
|
Sink and the American Standard logo is facing rear. Rotate Stopper | LOGO |
slightly if necessary so that the Stopper slides all the way down. |
|
Fig. H. |
|
180˚ | |
| |
to make sure it is fully inserted. Fig. J. |
|
LOOP TOWARD | |
FRONT OF SINK | |
outward. If the Cam Cap does not “snap” into place, then rotate |
|
the Cam to make sure it is fully inserted. Fig. K. | DRAIN |
“Troublingshooting Guide” to complete installation. Stopper will beUnlocked Mode in “Unlocked” mode and removable.
Fig. J.
CAM
Fig. K.
INSTALL CAM
INSTALL CAM CAP
M968672 Rev . 1 . 1
6