American Standard 605XTMV To Adjust Temperature Fig, To Service Cartridge Fig

ADJUST TEMPERATURE

4TO ADJUST TEMPERATURE; Fig. 6

1.Adjust temperature by inserting a 4mm Hex Wrench into hex opening in the side of enclosure. Fig. 6.

2.To decrease temperature, rotate up. (clock-wise)

3.To increase temperature, rotate down. (counter- clockwise)

Fig. 6

TO DECREASE TEMPERATURE

4mm HEX WRENCH

TO INCREASE TEMPERATURE

SERVICE

5	TO SERVICE CARTRIDGE; Fig; 7
1.	Turn off water supply.
2.	Remove MIXING VALVE ENCLOSURE COVER.
3.	Disconnect MIXING VALVE (1) from SELECTRONIC
ENCLOSURE (2). Fig. 7.
4.	Pull MIXING VALVE (1) out from ENCLOSURE (5).

Fig. 7 2

1

Fig. 7a

6, 4

1

5

3

If SUPPLY HOSES (3) are not long enough to gain access to TEMPERATURE CALIBRATION UNIT (6) &THERMOSTATIC CARTRIDGE (4) disconnect SUPPLY HOSES (3) from wall valves. Fig. 7a.

5.	Rotate the BLACK CLAMP (7) with your finger and
pull off the TEMPERATURE CALIBRATION UNIT (6).
Fig 7b, 7c.
6.	Use a adjustable wrench to unthread
THERMOSTATIC CARTRIDGE (4) from housing. Fig. 7d.
7.	Remove THERMOSTATIC CARTRIDGE (4). Fig. 7e.
8.	Rinse clean any debris from SCREENS (8) and
inspect O-RINGS (9) for damage. Replace O-RINGS (9)
if any damage is found. Fig. 7f.
9.	Reverse above steps and reassemble MIXING
VALVE (1). Assemble MIXING VALVE (1) to
SELECTRONIC ENCLOSURE (2).
10. Assembly ENCLOSURE COVER and tighten

Fig. 7b Fig. 7c

6

7

Fig. 7d Fig. 7e

4

4

securley.

Fig. 7f

8

9 4

3