STOPPER INSTALLATION PROCEDURE
The Stopper can be installed two ways, “Locked” Mode (Stopper cannot be removed) or “Unlock” Mode (Stopper is removable).
Locked Mode:
Look at the Plastic Loop at the bottom of the Stopper and notice | Fig. G. | |
that the Loop is on one side of the Stopper. Fig. G. | ||
To install the stopper in “Locked” mode, insert the Stopper into | LOGO | |
the Drain so that the Plastic Loop is facing toward the rear of the |
| |
Sink and the American Standard logo is facing front. Rotate |
| |
Stopper slightly if necessary so that the Stopper slides all the |
| |
way down.Fig. G. |
| |
| ||
to make sure it is fully inserted. Fig. J. | LOOP TOWARD | |
| ||
REAR OF SINK | ||
| ||
outward. If the Cam Cap does not “snap” into place, then rotate | DRAIN | |
the Cam to make sure it is fully inserted. Fig. K. | ||
| ||
Locked Mode | ||
Troubling Shooting Guide to complete installation. Stopper will be | ||
(Vandal Proof) | ||
in “Locked” mode and not be removable. | ||
Unlocked Mode: |
| |
Look at the Plastic Loop at the bottom of the Stopper and notice | Fig. H. | |
that the Loop is on one side of the Stopper. Fig. H. | ||
To install the stopper in “Unlocked” mode, insert the Stopper into | LOGO | |
the Drain so that the Plastic Loop is facing toward the front of the |
| |
Sink and the American Standard logo is facing rear. Rotate Stopper |
| |
slightly if necessary so that the Stopper slides all the way down. |
| |
Fig. H. |
| |
180˚ | ||
| ||
to make sure it is fully inserted. Fig. J. |
| |
LOOP TOWARD | ||
FRONT OF SINK | ||
outward. If the Cam Cap does not “snap” into place, then rotate |
| |
the Cam to make sure it is fully inserted. Fig. K. | DRAIN |
“Troublingshooting Guide” to complete installation. Stopper will beUnlocked Mode in “Unlocked” mode and removable.
Fig. J.
CAM
Fig. K.
INSTALL CAM
INSTALL CAM CAP
M968868 Rev 1 . 2
6