| Installation | |
TRIUMPH | Instructions | |
7038 | ||
Widespread Lavatory Faucet with | ||
Speed Connect™ Drain |
|
Congratulations on purchasing your American Standard faucet with Speed Connect drain, a feature found only on American Standard faucets.
Speed Connect™ Drain*
•Fewer parts, installs in less time
•Never needs adjustment
•Guaranteed to seal properly the first time, every time.
Certified to comply with ANSI A112.18.1
M968868 Rev 1 . 2
*Your new American Standard faucet is designed to work only with the Speed Connect drain. Heplful tips for removing your current drain can be found in the Troubleshooting section of these instructions.
To ensure that your installation proceeds
Recommended tools |
|
|
|
| |
| Screwdriver | Channel Locks | Adjustable Wrench | Tubing Cutter | |
1 | INSTALL SPOUT | CAUTION | Turn off hot and cold water |
| |
supplies before beginning. | Fig. A. | ||||
|
|
|
|
Insert SPOUT (1) and CABLE CONNECTOR (12) through center hole, making sure the SPOUT ESCUTCHEON (2) and SEAL WASHER (3) are properly seated.
Assemble RUBBER WASHER (4), BRASS WASHER (5) and LOCKNUT (6) onto SPOUT SHANK (7) from under side of sink . Make sure SPOUT (1) is centered in the mounting hole and the slot in the BRASS WASHER (5) faces toward the rear of the sink.
Tighten LOCKNUT (6) firmly. Fig. A.
1A INSTALL VALVE BODY2 3
7
Place RUBBER RING (9) into SCUTCHEON (10).
Install LOCKNUT (11) onto VALVE BODY (8).
From under side of mounting surface, install VALVE BODY (8) through valve mounting holes. Threads of VALVE BODY (8) should extent at least 5/16 of a inch above mounting surface top. Fig. B. Thread ESCUTCHEON (10) onto VALVE BODY (8) until snug against internal stop. If necessary, adjust LOCKNUT (11).
Hand tighten LOCKNUT (11) to secure VALVE BODY (8). | 1 |
Repeat above steps for opposite VALVE BODY (8A). |
4
SLOT 5
612
9
5/16'' MIN.
Fig. B.10
MOUNTING 9
SURFACE
11 88 11
8A
1