710007-100
2
1
3
INSTALLATION PROCEDURES:Determine side at which the door will pivot (left or right).
The pivot side should be opposite the showerhead.
Measure width of the opening at the centerline of bottom.
NOTE: This door swings out only. Verify door will clear any
obstructions before installing.
Position pivot plate on threshold with undrilled end of plate
toward pivot jamb.
Bolt pivot plate in place using pivot bolt and 1/4" nut.
4
Mount threshold to pivot jamb using three #8 x 1/2" pan
head screws. The wide side of the pivot jamb fits inside
front lip of the threshold.
2
Flat edge of threshold should face inside of shower.
Identify end of threshold which will be pivot side.
Mark the OPPOSITE end for drilling. Cut threshold to size
W measured in step 1.
5
Attach top pivot arm to top of the pivot jamb using three #8
x 5/8" Phillips head screws. (Ensure pivot jamb fits in slot in
pivot arm).
#8 x 5/8" Flat Head Screw (Actual Size)
6
Position assembled pivot jamb to wall with threshold
centered on the shower base.
Mark holes in jamb for drilling.
Use a level to ensure jamb is plumb.
W
MEASURE
TOP VIEW
CENTERLINE
IMPORTANT:
ENSURE
BASE IS LEVEL
FLAT EDGE
THRESHOLD
CUT END
OPPOSITE
PIVOT SIDE
PIVOT JAMB
(AT THIS END)
PIVOT BOLT & NUT (ACTUAL SIZE)
UNDRILLED END
#8 x 1/2" PAN HEAD SCREW (ACTUAL SIZE)
(VIEW FROM
INSIDE SHOWER) WIDE SIDE OF
PIVOT JAMB
THRESHOLD
LEVEL
PIVOT SLOT
PIVOT ARM
PIVOT JAMB
Record Measurement: W = ____________ inches For best results use a 32-tooth hacksaw blade and a
miter box.