American Standard 710007-100 owner manual Flat head screws

7		8
	Remove pivot jamb with threshold. Drill six holes using a		Apply 1/4" bead of silicone caulk where bottom of pivot
	3/16" drill bit. (Use a masonry bit for ceramic tile.)		jamb and threshold meet (see inset detail).
	Insert one screw anchor in each hole.		Mount assembled pivot jamb to wall using six #8 x 1-1/2"
			flat head screws.

NOTE: When drilling into fiberglass or plastic walls, use a 1/8" drill bit and do not use screw anchors.

SILICONE

CAULK

SCREW ANCHOR

					#8 x 1-1/2" Phillips Flat Head Screw (Actual Size)
9					10
Subtract door panel width DW from length W in step 1. If					Install door by mating bottom pivot bolt with nylon pivot bushing.
difference is from 1-3/4" to 3-1/8" use the minimum hole.
If difference is from 3-1/8" to 4-1/2" use maximum hole.					Align door with top pivot arm and insert pivot bolt through arm
Insert one nylon pivot bushing in each of selected holes top					into 1/4" nut, and then into corresponding nylon pivot bushing.
and bottom.		IF			Adjust door by sliding it in pivot slot top and bottom to allow
	1-3/4" < W – DW < 3-1/8"				1-3/8" to 1-7/8" of space between wall and magnet side of door
		USE MINIMUM
					when in closed position.
	ADJUSTMENT HOLE		NYLON PIVOT
		IF	BUSHING		Tighten nut against pivot arm for proper tension using 1/4"
DOOR
	3-1/8" < W – DW < 4-1/2"		MIN	MAX	wrench.
WIDTH		USE MAXIMUM
			HOLE	HOLE
DW	ADJUSTMENT HOLE
	W	inches
W	— DW	inches
		inches
					1/4" WRENCH PROVIDED

11	On side opposite pivot jamb, drill a 1/8" hole in threshold	12	Temporarily secure threshold with masking tape at strike
	located 5/8" from wall and 7/8" from flat edge of threshold.		side. Ensure an even distance between edge of threshold
	Fasten positioning spacer to threshold using one #8 x 1"		and front of the base.
			Locate adjustment rail over positioning spacer and against
	pan head screw.
			wall (you may reverse rail to mark holes). Use a level to
	For doors with narrow strikes (e.g. Model #804NS) position-		plumb adjustment rail.
	ing spacer is not necessary. Instead mark a line 7/8" in from		Mark hole location of the large holes only. Remove rail. Drill
	flat edge and parallel to it. Center adjustment rail over this
	line when installing in step #12.		six 3/16" diameter holes then insert wall anchors.
			ADJUSTMENT	TOP VIEW
			RAIL

POSITIONING

SPACER 5/8"

7/8"

#8 x 1" Pan Head Screw (Actual Size)

Plastic Screw Anchor (Actual Size)

3 7 1 0 0 0 7 - 1 0 0