SWING SPOUT ASSEMBLY
CAUTION | Turn off hot and cold water | |
supplies before beginning. | ||
|
Apply the grease (provided) liberally to the
SPOUT
Assemble the SPOUT (3) and tighten the
SPOUT NUT (4) until snug on VALVE BODY.
FITTING INSTALLATION
Remove LOCKNUT (1), BRASS WASHER (2), and
GASKET (3) from fitting.
Place RUBBER RING (4) in recess of fitting.
Insert inlet hoses (on model 7190 only) and |
|
|
THREADED SHANK through hole of sink making | MODEL 7190 | MODEL 7100 |
certain RUBBER RING (4) is properly seated in the | ||
recess of the fitting base. |
|
|
3
4
2
1
Assemble GASKET (3), BRASS WASHER (2), and LOCKNUT (1) onto the THREADED SHANK from underside of sink deck.
Tighten the LOCKNUT (1) securely.
For Model 7190 Only
Connect the hot water supply to the left inlet hose and the cold water supply to the right inlet hose using appropriate connectors.
For Model 7100 Only
Connect hot or cold water supply lines to shank using sealant, appropriate connectors, and coupling nuts.
RECESS
4
RECESS
SHANK
3
2
HOT1
FLEXIBLE | COLD | SUPPLY |
INLET HOSES | NUT |
TEST INSTALLED FAUCET
Remove AERATOR.
Operate both handles to flush water lines thoroughly. Checkspout mounting and hose connections for leaks.
With handle in OFF position, turn on water supplies and check all connections for leaks.
Turn handles into OFF position and replace AERATOR.
SERVICE | 2 | 90p | |
|
| ||
| To change direction of handle rotation, | 1 | |
proceed as follows:
Turn valve to OFF position.
Remove INSERT and HANDLE SCREW.
Slip HANDLE with ADAPTER off.
Remove SPRING CLIP (1).
Lift STOP WASHER (2), turn 90p and replace.
Replace SPRING CLIP (1).
Replace ADAPTER, HANDLE, SCREW, and INSERT.
AERATOR may accumulate dirt causing distorted and reduced water flow. Remove AERATOR and rinse clean.
If spout drips, operate handles several times from OFF to ON position. Do not force - handles turn only 90p.
Plastic SCREEN (3) in CARTRIDGE (4) may accumulate dirt causing reduced water flow. To clean, first turn off hot and cold water supplies, then:
| Remove INSERT and HANDLE SCREW. | 4 |
| ||
| ||
| Slip HANDLE with ADAPTER off. | |
| ||
| ||
| Unscrew CARTRIDGE (4) with wrench. |
|
|
| |
|
| |
| Thoroughly rinse plastic SCREEN (3) at |
|
|
| |
|
| |
| base of CARTRIDGE (4). |
|
| Replace CARTRIDGE (4) until flange is | 3 |
| ||
| ||
| tight against valve body. | |
| Turn valves OFF. |
|
|
| |
|
|
Replace ADAPTER, HANDLE, SCREW,
and INSERT.
EverClean™ Finish Care Instructions
American Standard’s EverClean finish will wipe clean with a soft, dry cloth. A soft cloth with clean water may also be used, if desired. No additional cleaning products are required.
DO NOT USE: Soaps, acid, polish, abrasives, harsh cleaners, or a cloth with a coarse surface.
3 & 7
