TOOLS AND SUPPLIES REQUIRED
|
| Teflon Tape |
Channel Locks | Adjustable Wrench | Drill |
Plumbers' Putty or | ||
|
| Caulking |
1 SINGLE AND DUAL CONTROL
LABORATORY FITTINGS
IMPORTANT: FLUSH ALL SUPPLY LINES PRIOR TO FITTING INSTALLATION.
For vandal resistant fitting only, a pin hole will be need to be drilled into the deck offset from the mounting shank hole. Note: For vandal resistant models it is important to obtain the
For vandal resistant fitting apply putty to underside of fitting base to assure a good seal and level fit.
When installing a vandal resistant fitting, align pin with pin hole in mounting surface.
For standard fitting, assemble rubber washer onto body shank.
Place body shank through hole in deck and assemble steel washer and lock nut. Tighten securely.
Pipe to correct service to complete installation.
After installation is complete turn service on and check all connections for leaks.
SINGLE CONTROL | DUAL CONTROL | |
LABORATORY FITTINGS | ||
LABORATORY FITTINGS | ||
7272.201 | ||
7272.120 | 7272.220 | |
7272.121 | 7272.221 | |
7272.121VR | 7272.221VR |
FITTING |
|
|
| |
BASE |
|
| FITTING | |
|
|
| ||
PUTTY |
|
| BASE | |
| VANDAL RESISTANT PIN |
| PUTTY | |
RUBBER WASHER | ON VANDAL RESISTANT |
| VANDAL RESISTANT PIN | |
FITTINGS ONLY |
| ON VANDAL RESISTANT | ||
(NOT USED ON |
| |||
|
| FITTINGS ONLY | ||
VR FITTINGS) | RUBBER WASHER | |||
| ||||
| (NOT USED ON |
| ||
| BODY | VR FITTINGS) |
| |
|
| BODY | ||
| SHANK |
| ||
|
| SHANK | ||
|
|
| ||
| OFFSET HOLE FOR |
|
| |
| VANDAL RESISTANT PIN | OFFSET HOLE FOR | ||
|
|
| ||
| STEEL WASHER |
| VANDAL RESISTANT PIN | |
|
|
| ||
| LOCK NUT |
| STEEL WASHER | |
|
|
| ||
|
|
| LOCK NUT | |
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR
WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH,
ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A
COARSE SURFACE.
M 9 6 8 4 8 7
