TOOLS AND SUPPLIES REQUIRED
|
| Teflon Tape |
Channel Locks | Adjustable Wrench | Drill |
Plumbers' Putty or | ||
|
| Caulking |
1 INSTALL DECK MOUNT LABORATORY FITTINGS
CAUTION
Turn off hot and cold water supplies before beginning.
Drill two
Assemble rubber washers onto fitting shanks.
Insert fitting shanks through holes of mounting surface.
Assemble steel washers and lock nuts onto fitting shanks. Align fitting and tighten lock nuts securely with wrench.
2 | MAKE WATER SUPPLY CONNECTIONS |
IMPORTANT: FLUSH ALL SUPPLY LINES PRIOR TO | |
FITTING INSTALLATION. |
NOTE: FLEXIBLE SUPPLIES OR
MUST BE PURCHASED SEPARATELY.
Connect water supplies to faucet with 3/8" O.D.
kink copper supply when bending. Use tubing cutter to cut to proper length.
After installation is complete turn service on and check all connections for leaks.
FITTING
FITTING
FLANGE
FITTING
SHANK
RUBBER
WASHER
STEEL 
WASHER
LOCK NUT 
3/8" O.D. 
OR 1/2" IPS FLEXIBLE SUPPLIES
COUPLING NUT 
SUPPLIED WITH
FITTING
1 INSTALL WALL MOUNT LABORATORY FITTINGS
CAUTION
Turn off hot and cold water supplies before beginning.
for installation and must be ordered separate
Use appropriate
wall escutcheon onto 
union swivels
with 
adjustable wrench untilare flush against finished wall.
Note: Center to center dimension of swivel nuts are 8" [203mm].
WALL
ESCUTCHEON
COLD
SWIVEL
8"
[203mm]
MTG. SHANK KIT RDERED SEPARATELY)
UNION
SWIVELS
2 |
| MAKE WATER SUPPLY CONNECTIONS |
| IMPORTANT: FLUSH ALL SUPPLY LINES PRIOR TO | |
|
| FITTING INSTALLATION. |
Align 
to swivel nuts, if swivel nuts don't align with
Insert 
into swivel nuts if not already installed. Tighten both swivel nuts to make water tight connections.
Complete installation, turn on water and check for leaks.
FITTING INLET
SEAL WASHER
SWIVEL
NUT
UNION
SWIVEL
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.
