American Standard 7812.295, 7812.002 Sink and Console Table LEG Installation

1	2
#3	Place a middle leg tube	#5
	(Item #4) over each
	threaded rod. Identify the
	shelf support pins at the
	inner corners of the Shelf
#2	Support (Item #5). Guide
	each threaded rod through
	the corners of the shelf
#1	support so that these
	support pins are nearer to
	you.
Run the two front leg sub-assemblies (Item #1) through the
two front holes of the towel bar (Item #2). Do the same with
the two rear leg assemblies (Item #3). Adjust the hex nut at	#4
the end of each rear leg such that 5/8" of thread is exposed.
Turn the unit upside down.
3	4	#8
	#7
#6
#5

	Thread one decorative foot (Item #7) onto the end of each rod
	until the leading end of the rod is recessed with the foot to a
	depth of 1/4". Set the unit upright and thread one leveling
	trumpet (Item #8) on the top of the rear legs.
	Note: To prevent breakage, put the rectangular glass
Place a bottom leg tube (Item #5) over each threaded rod	shelf in place only after the sink and console legs are
	completely assembled and the sink has been bolted to
such that the closed end of each is nearer to you. Thread one	the wall.
hex nut from the kit (Item #6) onto each rod. Lay the unit
down and tighten each of the four legs firmly. Maintain the	Upon completion of console assembly, follow installation
5/8" of exposed thread at the top end of the rear legs. Once	procedure below.
again, set the unit upside down.

SINK AND CONSOLE TABLE LEG INSTALLATION

1

Note: If replacing an existing sink be certain to shut off water supply before removing old sink. If installing in a new bathroom follow rough-in diagram to locate rough supply, waste lines.

Provide suitable reinforcement behind finished wall for sink hanger screws. For an installed sink height of 36", center the reinforcement 29" above the floor.

C/L of 2 x 8

Support

and Bracket

30-3/4"

Finished

Floor

- 2 - 730757 - 100 REV . B