CONSOLE TABLE INSTALLATION
Choose a location that provides enough clearance for side doors to open freely.
Provide suitable reinforcement required for anchoring the vanity to the wall. Centerline of reinforcement should be 31- 3/4" up from the floor (see Figure 1).
The molding needs to be notched to seat the vanity flush against the wall (see Figure 2).
Rough in supply lines and waste per rough in dimensions.
Drill at least two 3/8" O.D. anchoring holes through the centerline of the rear stringer of the console table. The centerline is located
Move the vanity into place and level with the adjustable glides on the bottom of the feet. The glides can be adjusted outward up to 1" but it is recommended not to exceed 1/2" if possible. Anchor it to the wall through at least 2 of the anchoring holes in the rear of the vanity (see Figure 2).
Continue with installation appropriate for top and sink options chosen.
489m
C/L of 2 x 6
Reinforcement
FIGURE 1
Finished
Floor
| |
| 38mm |
| ANCHORING |
FIGURE 2 | HOLES IN |
REAR STRINGER | |
ADJUSTABLE GLIDES |
|
(LOCATED UNDER |
|
EACH FOOT) |
|
| MOLDING |
Wood Top 9474.670 with Morning 0670 / Loft 0660
Two people recommended for this installation
Wood top is already cut out to accept the Morning Loft / Sink.
Mount the drain assembly on the sink. Be certain to apply a bead of sealing putty on the underside of the drain in order to ensure a watertight seal between the sink and drain. Remove excess putty.
Install the faucet on the sink per the manufacturer's instructions. Install the sink on the wood top using sealant. Add or remove excess compound around the base of the sink rim. Form fillet the sealant with wet finger or a sponge.
Position the wood top on the console table and secure the top with the 6 screws provided. Secure the wood top through the 6 brackets that are preinstalled on the console table.
- 2 - | 730551 - 100 Rev . C |
