NAD Guide to Operating and Navigating the T 765 Receiver

operation

USING THE T 765 – MAIN MENU

ABOUT THE ON-SCREEN DISPLAY (OSD)

The T 765 receiver employs a simple, self-explanatory system of on-screen display “menus” that will appear on the connected video monitor/TV. These are required during the setup process (and are useful in day-to-day operation), so be sure to connect the monitor/TV before proceeding with setup.

Note

The T 765’s OSD is available only at Component Video OUT, S-Video Monitor OUT and Composite

Video Monitor OUT. HDMI IN and HDMI OUT are direct pass-through signal without OSD.

DISPLAY THE OSD

Press either or ENTER buttons of the HTR 3 remote control or front panel to display the T 765’s Main

Menu on your video monitor/TV. If the OSD does not appear, check your MONITOR OUT connections.

NAVIGATING THE OSD AND MAKING CHANGES

To navigate through the OSD menu options, please do the following using the HTR 3 or corresponding

front panel buttons:
1.	Press	or ENTER to select a menu item. Use	keys or in some cases, ENTER, to move up or
	down the Menu selections. Repeatedly press		to advance or go further into sub-menus of a
	desired menu item.
2.	Use	keys to set or change the parameter value (setting) of a menu item.
3.	Press	to save the settings or changes done on the current menu or sub-menu. Pressing will

also return the user to the previous menu or exit from a particular menu.

MAIN MENU

The Main Menu contains the menu options for ‘Listening Mode,’‘DSP Options,’‘Tone Controls,’ ’Zone

Controls’ and access to ‘Setup Menu.’

To navigate through these Main Menu options and their sub-menu selections, please refer to and follow the directions stated in the sections ‘Display the OSD’ and ‘Navigating the OSD and Making Changes.’

Note

The individual configurations set forth at ‘Listening Mode,’ ‘DSP Options’ and ‘Tone Controls’ are carried over whenever they are enabled during A/V Preset setting. Please see the section ‘AV Presets’ for reference.

Listening Mode

The T 765 offers nine distinct listening modes, tailored for different types of recording or program material. With a two-channel (Stereo) source, the following listening modes can be selected:

Stereo

All output is directed to the front left/right channels. Low frequencies are directed to the subwoofer if one is present in the Speaker settings. Select ‘Stereo’ when you wish to listen to a stereo (or monaural) production, such as music CD or FM broadcast, without surround enhancement. Stereo recordings whether in PCM/digital or analog form and whether surround-encoded or not encoded, are reproduced as recorded. Multi-channel digital recordings (Dolby Digital and DTS) are reproduced in “Stereo Downmix” mode via the front left/right channels only as Lt/Rt (left/right-total) signals.

Dolby Pro Logic

Two-channel recordings, whether stereo or surround-encoded, are reproduced with Dolby Pro Logic surround processing, yielding output to front left/right, center and discrete left/right surround channels (assuming these are present in the current ‘Speaker Configuration’). The surround channel is monophobic, but it is reproduced in both surround speakers.

DOLBY PRO LOGIC PLII

Dolby Pro Logic II is a more recent evolution of the original Dolby Pro Logic surround processing that yields more stable imaging and full bandwidth sound to the rear channels in Movie mode, offering sound that is more similar to Dolby Digital decoding.

ENGLISH

FRANÇAIS

ESPAÑOL

ITALIANO

SVENSKA NEDERLANDS DEUTSCH

РУССКИЙ

13