operation
USING THE HTR 3 REMOTE CONTROL
Factory Reset
The HTR 3 can be reset to its factory state, deleting all learned commands, copied and punched- through keys, macros, and other setup information, reverting all keys to their
To perform a factory reset simultaneously
Note
You must release [ON] and [RTN] before the second flash goes out, otherwise the unit will not reset; should this occur, repeat the full procedure.
Delete Mode
The HTR 3 can store learned, copied, and “default library” commands on any single key (The default library commands are the
You can delete commands by layers back “down” to the default library command on any key, removing learned commands,
Note
The default library commands cannot be deleted, so you need not worry that using Delete Mode might cause irreparable changes.
To enter Delete Mode, simultaneously
Note
You may delete multiple
Flashes | Command Type |
1Default Library Command
2Copied Library Command
3Learned Command
ENGLISH
FRANÇAIS
ESPAÑOL
ITALIANO
SVENSKA NEDERLANDS DEUTSCH
РУССКИЙ
37