NAD T 765 owner manual identification of controls, Front Panel, English Français Español Italiano

identification of controls

FRONT PANEL

11 SOURCE : Press these buttons to toggle through the input selections – Source 1, Source 2, Source 3, Source 4, iPod, Source 7, Front Input, Media Player and Tuner. More Sources could be directly recalled through these buttons upon enabling them at the Setup Menu (See the section ‘Source Setup’ at Setup Menu discussion).

12LISTENING MODE : Use to step through the T 765’s Listening mode as discussed in the section ‘About the T 765’s Listening Modes.’ Depending on the format of the currently selected input (digital or analog, stereo or multichannel), various listening modes are available.

13TONE CONTROLS : Press to adjust TREBLE control using the VOLUME knob over a + 10dB range. Press again to adjust BASS control and a third time for DIALOG control. See also section about ‘Tone Controls’ under ‘Setup Menu’ discussions.

14TONE DEFEAT : Tone Controls are enabled or disabled by pressing this button. Tone controls are bypassed at ‘Tone Defeat’ while at ‘Tone Active,’ the tone controls are enabled again. See also section about ‘Tone Controls’ under ‘Setup Menu’ discussions.

15FRONT INPUT/MP : Use this button to directly select Front Input and Media Player. Toggle button to switch between Front Input and Media Player input.

16PHONES : Accepts stereo headphone using a standard 1/4-inch stereo phone plug (use a suitable adapter for headphones equipped with a smaller plug). For headphone listening, the Front speakers must be set to “Large” at the ‘Speaker Configuration’ of the Speaker Setup item at the Setup Menu, otherwise headphone bass response will be restricted. Plugging in headphones will automatically switch the T 765 to Stereo, Stereo Downmix or Analog Bypass modes.

17FRONT INPUT jacks : Use these convenience jacks for occasional sources such as a camcorder, tape player, video game console, any analog audio or optical digital audio and composite or S-Video video sources. If your source has a single audio out jack only or is marked ‘mono output’ , plug this into the T 765’s Front ‘R (Mono)’ input. On the other hand, if your source has two output jacks indicative of stereo output, insert both jacks into the T 765’s corresponding Front ‘L’ and ‘R (Mono)’ input to achieve stereo output as well.

18MP/MIC input : Connect your MP3’s standard stereo phone jack to this input. This is the same input where Audyssey microphone jack is connected (See also discussion about ‘Audyssey Setup).

ENGLISH

FRANÇAIS

ESPAÑOL

ITALIANO

SVENSKA NEDERLANDS DEUTSCH

РУССКИЙ