operation
USING THE T 765 – SETUP MENU
SETUP MENU
The Setup Menu allows one to customize the operation of the T 765 to the ancillary equipment used in one’s specific AV system. Unless your system exactly matches the factory defaults as shown in the accompanying Quick Start Guide, you will need to use the setup menu to configure the inputs of the T 765.
At Setup Menu, the following are configurable – Source Setup, Speaker Setup, Zone Setup, Amplifier
Setup, Trigger Setup, Listening Mode Setup, Display Setup and A/V Presets.
To access and navigate through Setup Menu and its
SOURCE SETUP
From Setup Menu, pressingwill direct you to the Source Setup menu wherein you could adjust allocate or change the settings of the following – Source Setup (Normal View), Source Setup (Table View) and iPod Setup.
Source Setup (Normal View)
The Source Setup (Normal View) menu makes it possible to set, allocate or change the following settings.
Source
The T 765 is equipped with ten configurable Sources. The settings for each Source are dependent on the configurations set forth in the parameters for that particular Source window.
To change or toggle through the Sources, scroll to ‘Source’, pressbutton and then ENTER orto move up or down the Source selections.
NOTE
Source 5 is defaulted to iPod. For Source 5 to be changed and allocated for other inputs, go to ‘iPod Setup’ menu under the ‘Source Setup’ menu. At iPod Setup menu, set ‘Enabled’ to ‘No’ – you can now assign Source 5 to other inputs or settings as desired.
Enabled
One can enable/disable a Source via this option. This is particularly useful if only few Sources are used and one directly selects the Source from the front panel, bypassing unused sources.
To enable or disable a particular Source, scroll to ‘Enabled’ and presskeys to select ‘Yes’ or ‘No’.
Name
A new Name maybe assigned to a Source label. For example, if your DVD player is attached to ‘Source 1’, it is possible to rename ‘Source 1’ to ‘DVD Player.’
In order to rename the Source label, scroll to ‘Name’ and pressto go the character. Then, press to pick through the alphanumeric selections.
Pressto move to the next character and at the same time save the changes done on the current character. The name can be as long as twelve characters.
The new Name will be shown in the VFD as well as on the OSD.
ENGLISH
FRANÇAIS
ESPAÑOL
ITALIANO
SVENSKA NEDERLANDS DEUTSCH
РУССКИЙ
17