American Standard 4077.014 Tank Install Wax Seal, Position Toilet On Flange, Install Toilet

4
SEALANT	WAX RING

INSTALL WAX SEAL

Invert toilet on floor (cushion to prevent damage), and install wax ring evenly around waste flange (horn), with tapered end of ring facing toilet. Apply a thin bead of sealant around toilet base.

5MANIFOLD INSIDE WATERWAY - DO NOT REMOVE

NUT

TAPERED

WASHER

CLOSET

BOLT

FLANGE

POSITION TOILET ON FLANGE

a.Unplug floor waste opening and install toilet on closet flange so bolts project through mounting holes.

b.Loosely install retainer washers and nuts. Side of washers marked "THIS SIDE UP" must face up!

6

BOLT CAP

CLOSET FLANGE

INSTALL TOILET

a.Position toilet squarely to wall and, with a rocking motion, press bowl down fully on wax ring and flange. Alternately tighten nuts until toilet is firmly seated on floor.

!CAUTION:

DO NOT OVERTIGHTEN NUTS

OR BASE MAY BE DAMAGED!

b.Install caps on washers.

(If necessary, cut bolt height to size before installing caps.)

c.Smooth off the bead of sealant around base. Remove excess sealant.

WASHER NUT

CLOSET BOLT

7

	RUBBER
TANK MTG.	GASKET
BOLTS PRE-
INSTALLED

WASHER/NUT

INSTALL TANK

a.Install large rubber gasket over threaded outlet on bottom of tank and lower tank onto bowl so that tapered end of gasket fits evenly into bowl water inlet opening, and tank mounting bolts go through mounting holes. Secure with metal washer/nuts.

b.With tank parallel to wall, alternately tighten hex nuts until tank is snugged down evenly against bowl surface.

Recommended tool: Deep socket tool included in tank kit.

!CAUTION: DO NOT OVERTIGHTEN NUTS MORE THAN REQUIRED FOR A SNUG FIT!

DO NOT SPIN BOLTS WITH SCREWDRIVER

8INSTALL TOILET SEAT Install toilet seat in accordance with manufacturer's directions.

9a Before continuing, determine the type of water supply connection you have from the chart below and use the appropriate assembly parts required to properly reconnect the water supply. DO NOT use plumber's putty to seal these fittings.

METAL/COPPER	METAL FLANGED	METAL SPIRAL	VINYL/BRAIDED
FLARED TUBING	TUBING	TUBING	CONNECTOR
LOCK NUT	LOCK NUT	LOCK NUT	LOCK NUT
CONE	EXISTING	EXISTING	COUPLING
	WASHER
WASHER		CONE	NUT
COUPLING	EXISTING	WASHER
	COUPLING	COUPLING
NUT
	NUT	NUT
WATER	WATER	WATER	WATER
SHUT-OFF	SHUT-OFF	SHUT-OFF	SHUT-OFF
These parts must be used as	Use existing	Use existing spiral cone	Captive cone
illustrated to insure water-tight	coupling nut	washer. Fluidmaster	washers already
connection. Use of existing coupling	and washer.	cone washer may not	included. No
nut may result in water leakage.		seal completely on	additional washers
Water supply tube or pipe must		spiral type supply line.	needed.
extend at least 1/2" inside threaded
shank of valve (does not apply to
flanged tubing).

CAUTION: DO NOT USE CONE WASHER WITH PLASTIC SUPPLY LINE.

CAUTION: Overtightening of LOCK NUT or COUPLING NUT could result in breakage and potential flooding.

- 2 - 730945-100 Rev. C