Installation
Instructions
T M2021.6XX
KITCHEN FAUCETS
Thank you for selecting American-Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds |
|
| |
please read these instructions carefully before you begin. | Certified to comply with ASME A112.18.1M | ||
|
|
| M66240 REV.1.1 |
TOOLS REQUIRED |
|
|
|
Channel Locks | Adjustable Wrench | Plumbers' Putty or Caulking | Phillips Screwdriver |
1
CAUTION | Turn off water at |
main supply. |
Install ESCUTCHEON (optional)
Peel off paper backing from WASHER (1, 1a) and stick WASHER (1, 1a) into circular groove of the SUPPORT PLATE (2, 2a).
Place SUPPORT PLATE (2, 2a) in |
|
| |
center of ESCUTCHEON (3, 3a) |
|
| |
with WASHER (1) visible. | 1 | 2 | |
Turn ESCUTCHEON (3, 3a) over | |||
|
| ||
with notch of SUPPORT |
| INSTALL | |
PLATE (2, 2a) towards rear of |
|
| |
sink, align STUDS (4) with | 4 |
| |
outer holes of sink and |
| ||
place ESCUTCHEON (3, 3a) onto |
|
| |
deck. Hole of SUPPORT |
|
| |
PLATE (2, 2a) must align with |
|
| |
hole of sink. |
| EDGE | |
|
| ||
|
| REAR |
3
FOR MODEL 2021.631 ONLY:
Install ESCUTCHEON (3a) (as described on the left).
Insert SPRAY HOLDER (5) through side hole of installed ESCUTCHEON (3a), thread WING NUT (6) to shank of SPRAY HOLDER (5) from underside of sink. Center SPRAY HOLDER (5) on ESCUTCHEON (3a) and secure by tightening WINGNUT (6).
5
3a | 2a |
| INSTALL |
|
| ||
4 |
|
|
|
6 | REAR | EDGE | 3a |
|
| ||
|
|
|
2 FAUCET INSTALLATION (ESCUTCHEON OPTIONAL)
Insert supply TUBES (1) and threaded MOUNTING STUD (2) through center hole of ESCUTCHEON (3) and sink deck, or selected sink hole if ESCUTCHEON (3) is not used.
Make sure black RUBBER GASKET (4) is properly centered on base.
Orient faucet so that threaded STUD (2) is centrally located towards rear of sink, then assemble RETAINER PLATE with GASKET (5), or MOUNTING KIT (5a) and thread LOCKNUT (6, 6a) onto MOUNTING STUD (2) from underside of sink.
Hand tighten LOCKNUT (6, 6a) and check that rotation of HANDLE (7) from HOT to COLD is centered. Secure faucet by tightening LOCKNUT (6, 6a) firmly. Spread TUBES (1) for better access to LOCKNUT (6, 6a).
If using ESCUTCHEON (3), thread ESCUTCHEON WING NUTS (8) onto studs from underside of sink and
7
2 4
3 | 1 |
8 | 5 |
6 |
|
LESS ESCUTCHEON
4
1
5 |
6 |
LOCKNUT (FAUCETS LESS SPRAY)
6a
LOCKNUT
5a | 6a |
MOUNTING KIT |
FOR FTG. WITH
HAND SPRAY