5 INSTALL SPRAY HOLDER
NOTE: FAUCET can be installed with or without Hand Spray.
Place SPRAY HOLDER (1) into separate hole of SINK (2)
and assemble NUT (3) onto shank from underside of SINK (2).
Hand tighten NUT (3).
1
2
3
6 FITTING WITH SPRAY
Unscrew SPRAY CAP (5) from HOSE ADAPTOR (4).
Feed SPRAY HOSE (1) through SPRAY HOLDER (2) and attach COUPLING NUT (3) of HOSE (1) to HOSE ADAPTOR (4) on valve body. Tighten COUPLING NUT (3) firmly.
4
5 
3
1
2
7 TEST INSTALLED FAUCET
Remove AERATOR. With handles in OFF position, turn on water supplies and check all connections for leaks.
Operate both HANDLES to flush water lines thoroughly. Rotate SPOUT in both directions. Replace AERATOR.
Direct SPRAY HEAD into sink and activate SPRAY. Check HOSE connections for leaks.
AERATO
8 SERVICE
To change direction of handle rotation, proceed as follows:
Turn valve to OFF position.
Pull out INDEX CAP (1) and remove HANDLE SCREW (2).
Pull off HANDLE (3), and unscrew ESCUTCHEON (4).
Pull off STEM ADAPTER (7).
Remove SPRING CLIP (6).
Lift STOP WASHER (5), turn 90 degrees and replace.
Replace SPRING CLIP (6) and STEM ADAPTER (7).
Reinstall ESCUTCHEON (4) and HANDLE ASSEMBLY (1,2 & 3).
1
2
3
4
7
90
5
6
If faucet drips proceed as follows:
Aerator may accumulate dirt causing distorted and reduced water flow. Remove aerator and rinse clean.
If spout drips, operate handles several times from OFF to ON position. Do not force - handles turn only 90 .
9 CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.
M 9 6 8 4 1 2 A
