American Standard Wall Hung Bathroom Sink Installation Instructions

INSTALLATION INSTRUCTIONS

Wall Hung Bathroom Sink

*NOTE: For installation of models using concealed or exposed arms, follow instruction provided by arms manufacturer.

Introduction: Thank you for selecting our products...products which have been the benchmarks of fine quality for years. To help insure that the installation process will proceed smoothly, please read these instructions carefully before you begin. Also, review the recommended tools and materials list; carefully unpack and examine your new plumbing fixture.

!CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE! NOTE: Pictures may not exactly define contour of china and components.

Recommended Tools & Materials
			Basin Wrench
			Tape
			Measure
	Putty Kinfe	Adjustable Wrench
		Plumbers' Putty or
		Caulking
	Pipe Wrench	Drill	Hacksaw
			Saber Saw
		Tubing Cutter
		Phillips Screwdriver	Regular Screwdriver
Level	Channel Lock Pliers

1 Provide suitable reinforcement behind	C/L of 2X8	Hanger
finished wall for lavatory hanger mounting	Support	Location
screws. *Determine horizontal center line
location of support from the table listed in
Step 2. (Make sure support bottom	*
extends to lavatory back wall bottom.)
NOTE: If replacing an existing sink be
certain to shut off water supply before	Finished
removing old sink.
	Floor
2	TABLE
Part #	Model	Distance "A"

Determine the	0124	Comrade	- 2-1/2" (64mm)
desired rim height	0321	Declyn	- 2-3/4" (70mm)
(for example 32")	0355/0356	Lucerne	- 1" (25mm)
	0372/0373	Penlyn	- 1/8" (3mm)
then select from the
	4300	Ledgewood	+ 2-7/8" (73mm)
Table at right the	4867/4869	Regalyn	+ 2-3/4" (70mm)
height of the hanger	5300	Ledgemere	+ 2-1/2" (64mm)
			C/L OF HANGER
mounting bolts
			ANCHORING SLOTS
centerline			HANGER
	A
EXAMPLE:
For Lucerne:			HOLES FOR
32"-1"=31"
	RIM		ANCHOR
For Ledgewood:	HEIGHT		SCREWS
			DRAPERY
			IN BACK
32"+2-7/8"=34-7/8"	*		SUPPLIES AS
			REQUIRED
		WASTE
		FINISHED FLOOR

3

Position hanger according to Step 2, making sure its center is aligned with the waste hole centerline. Mark the hanger screw locations through its mounting holes.

4

Drill pilot holes in positioning screw slots of hanger. (Note: Some models are supplied with anchor screws, or steel hangers for lavatory installations. Other models are not provided with mounting hardware which can be purchased at local hardware outlets. Lavator-ies with bottom anchor screw holes should be secured with anchor screws in addition to hangers.

MOUNTING SCREW

HOLES (4)

POSITIONING

SCREW SLOTS (2)

© American Standard Inc. 2003 730427-100 Rev. B