SERVICE | 4 |
If faucet drips, operate handle several times from "off" to "on". Do not apply excessive force.
Clogged CARTRIDGE (1) inlets may cause reduced flow in "full on" hot or cold. To clean inlets, first turn off water supply, then:
Remove HANDLE (2).
)
0'' | $ |
7
1
5
3
Remove two SCREWS (6) holding ESCUTCHEON (7) | 6 |
and remvoe ESCUTCHEON (7). |
|
Remove CAP (3), SCREWS (5) and CARTRIDGE (1). |
|
Clean inlets and MANIFOLD (4). |
|
Reassemble CARTRIDGE (1), alternately tightening SCREWS (5). | 2 |
Replace CAP (3) and HANDLE (2). Check flow.
SERVICE: VALVE LEAKS WHEN SHUT OFF
Remove handle and trim.
Remove CARTRIDGE (1) by removing CARTRIDGE SCREWS (2). Remove three SCREWS (3) from FIXATION RING (4) and pull out PRESSURE BALANCING (5) unit.
Clean SEALS (9) on base of CARTRIDGE (1). Check base of PRESSURE BALANCING UNIT (5) and clean
Turn on water supply and see above for installing TRIM and HANDLE.
UNABLE TO MAINTAIN CONSTANT TEMPERATURE
Remove PRESSURE BALANCE UNIT (5).
Remove CAPS (7) and clean valve thoroughly.
Examine balancing unit and check condition of
Replace CAPS (7) and install PRESSURE BALANCE UNIT (5). Make sure inlets line up with two holes in bottom of casting. Top flange should
BACK TO BACK INSTALLATION
Remove PRESSURE BALANCE UNIT (5). Rotate PRESSURE BALANCE UNIT (5) 180˚ so that the inlets face up and the large outlet port faces down.
Push PRESSURE BALANCE UNIT (5) in casting make sure inlets line up with holes in bottom of casting. Top flange should butt up against top of casting.
Reassemble FIXATION RING (4) and CARTRIDGE (1).
6
4
|
| 1 | LARGE OUTLET |
8 | 7 |
| 5 |
|
| ||
|
|
| |
| 5 | 3 | INLETS |
|
| 2 | |
|
| 9 | |
|
|
|
ROTATE 180˚
BACK TO BACK INSTALLATION
EverClean™ Finish Care Instructions
American Standard’s EverClean finish will wipe clean with a soft, dry cloth. A soft cloth with clean water may also be used, if desired. No additional cleaning products are required.
DO NOT USE: Soaps, acid, polish, abrasives, harsh cleaners, or a cloth with a coarse surface. .