Tips before installation

Your Room Air Conditioner unit is designed to

be highly efficient and save energy. Follow these recommendations for greater efficiency.

1.Select thermostat setting that suits your comfort needs and leave the thermostat at that chosen setting.

2.The air filter is very efficient in removing airborne particles. Keep the air filter clean. Typically, the filter should be cleaned once a month. More

frequent cleaning may be necessary depending on outdoor and indoor air quality.

3.Use drapes, curtains, or shades to keep

direct sunlight from heating your room, but

! CAUTION !

To avoid installation/operating difficulties, read the instructions thoroughly.

NOTE: Save the shipping carton and packing materials for future storage or transport of the unit. Please check the contents of the hardware kit against the corresponding model check list, prior to installation of the unit.

See lists below.(Fig.A)

Fig. A Installation Hardware

DO NOT obstruct the air conditioner. Allow air to circulate around the unit without obstructions.

4. Start your air conditioner before outdoor

air becomes hot/cold and uncomfortable. This

3/4"Screws (10)

1/4"Screws (23)

Top Channel(1)

Shutter Clamp(2)

Washer(10)

avoids an initial period of discomfort while

the unit is cooling or heating off the room.

5. When outdoor temperature is cool

enough, use HIGH or LOW FAN

only. This circulates indoor air, providing some cooling comfort, and utilizes less electricity than when operating on a cooling setting.

Your Room Air Conditioner was designed

for easy installation in a single or double-hung window. NOTE: This unit is NOT designed for vertical (slider type) windows.

Side Curtain RH(1)

Bottom Channel(1)

Side Curtain LH(1)

(For 10K to 12K models)

Bottom Channel(1)

(For 18K to 24K models

-Factory Installed)

Lock Washers(4)

1-1/2"x1/4 Bolts(4)

Seal(1)

 

1/4" Nuts(4)

 

 

Foam (1)

Mounting

Double

Brackets(2)

Angle

Adhering

Brackets(2)

Seal(1)

End Cap &

 

Leveling Legs(2)

 

NOTE: Surplus screw(s) for spare use.

Tools Needed for Window Installation

Screw drivers: Both Philips and flat head

Power drill: 1/8 inch diameter drill bit Pencil

Measuring tape Scissors Carpenters level

5

Page 6
Image 6
Admiral AAW-10CR1FHU, AAW-24CM3FHU, AAW-24CR3FHU, AAW-10CM1FHU, AAW-18CM3FHU Tips before installation, See lists below.Fig.A