American Standard T970.702 installation instructions T970.712, T970.722, T970.732

Installation Instructions

	T970.702
DECK-MOUNT BATH FILLER TRIM KIT	T970.712
with EverClean™ Finish	T970.722
Congratulations on purchasing your American Standard	T970.732
faucet with EverClean finish found only on American

Standard faucets.

EverClean Finish

•One wipe effortlessly removes spots

•Eliminates the need for cleaners and scrubbing

•Permanent surface protectant remains beautiful for the life of the faucet

•EverClean™ available on: Polished Chrome, Satin Nickel,

Stainless Steel, Polished Brass (or any combination of these finishes)

Certified to comply with ANSI A112.18.1 U.S. Patent No. D403,750

M968652 Rev. 1 . 1

To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.

Required tools				3
Phillips Screwdriver	Screwdriver		4	1
			5
	Drill with
		1		REMOVE ALL
	3/16” bit			2 BEVELBURRS AND
Channel Locks	Hacksaw
1 SPOUT INSTALLATION		2		1"- 1-1/2"
		FINISHED
		DECK

Complete FINISHED DECK before trim installation.

Turn off the water supplies.

Remove the GUARDS (1) from the VALVES (2). Remove the

GUARD (3) and 1/4" PLUG (4) from the SPOUT SHANK (5).

The SPOUT SHANK (5) height should be 1" to 1-1/2" above the FINISHED DECK. Cut the SPOUT SHANK (5) if necessary. Remove all burrs and bevel the end of the shank. Failure to do so may

damage the SPOUT O-ring during installation and cause water

leakage.19.8mm (23/32")

Drill a 3/16" hole in the finished deck. See TEMPLATE for location.

8.4mm

(21/64")

3/16" DIA. HOLE

18.6mm DIA. (47/64")

SPOUT SHANK

3/16" DRILLED HOLE

SPOUT

SHANK

FRONT

11 6 8

10

7

TEMPLATE FOR

SPOUT ROLL

PIN LOCATION

16

FINISHED

DECK

Lubricate the SPOUT ADAPTER O-RING (6) and

SPOUT O-RING (7).

Push SPOUT ADAPTER (8) on SPOUT SHANK (9)

and align slot in SPOUT ADAPTER (8) with 3/16"

drilled hole.

Tighten SPOUT ADAPTER SET SCREW (10) securely

with 4mm HEX KEY (11).

Remove the PLUG BUTTON (12) from the SPOUT (13).

13

12

9 15

3/16" DRILLED HOLE

Position the RUBBER RING (14) in the groove in
the base of the SPOUT (13). Push the SPOUT (13) down
onto the SPOUT ADAPTER (8) and tighten the	GROOVE
SET SCREW (15) securely with the 5mm HEX KEY (16).
Insert the PLUG BUTTON (12) into the SPOUT (13).	13

14

8

SPOUT

O-RING