SVPCL Bass Preamp
The Rear Panel:
15 | 16 | 17 | 18 | 19 | 20 | 21 |
15.AC LINE IN: Firmly insert the female end of the supplied AC power cord into this socket. The grounded power cord should only be plugged into a grounded power outlet that meets all applicable electrical codes and is compatible with the voltage, power, and freqency requirements stated on the rear panel.
16.FOOTSWITCH: Use this jack to connect the mono plug of a single but- ton footswitch for remote control of the Mute function.
17.PREAMP OUTPUT: Use these jacks to send the output signal to the input jacks of your power amplifier.
18.PRE/POST: Use this switch to select either a Pre or Post EQ signal at the Line Output jack (#20). When this switch is depressed, the signal is Post EQ and is affected by the settings of the front panel tone controls. With this switch in the out position the signal is Pre EQ, taken directly after the first tube stage.
19.GND LIFT/GND: When this switch is in the out position, the chassis ground at the Line Output jack (#20) is electronically disconnected. This helps reduce hum in the Line Output signal.
20.TRANSFORMER BALANCED LINE OUTPUT: Use this jack to send a line level signal from the preamp to a house mixing board, recording con- sole, or external amplifier.
21.TUNER OUTPUT: Use this jack to send a signal to an electronic tuner. When the Mute function is engaged (#3, #16), the signal at this jack is unaf- fected and remains present, allowing for silent tuning during a performance.
5
