AMX CB-TP17 specifications Before After, the OUTSIDE, Rough-In Box can be fastened to both studs

Before After

~14" to 16"

13.554" (34.43 cm)

17.07"
(43.36 cm)		Mounting
	Horizontal	tabs flush on
		the OUTSIDE
	support beam
		of sheetrock

FIG. 2 CB-TP17 Rough-In Box installation into a notched stud (showing before and after installation)

Use a block to secure the Rough-In Box to the notched stud

Stud

Drywall/sheetrock

Mounting tabs for NXD Wall Mount panel should be flush with the outside of the sheetrock

Inserted block bridges the gap between the Rough-In Box and the notched beam

Knockouts should be located on the left-side of the Rough-In Box, alongside the connectors

Stud fastening holes

Rough-In Box can be fastened to both studs)

Use four #8 flat-head Mounting Screws to secure the NXD

to the Rough-In Box

Secure Beam to block

Depth depends on the thickness of the Drywall

Notched stud

FIG. 3 Screw locations for Rough-In Box attachment in a pre-wall installation

For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s). 93-034-10 REV: B

10/08

©2008 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.

AMX reserves the right to alter specifications without notice at any time.

3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com