AMX NI-700/900 manual

Hardware Reference Guide

NetLinx Integrated Controllers

NI-700/900

NetLinx Integrated Controllers

Last Revised: 5/13/2008

Contents

Main AMX Limited Warranty and Disclaimer Table of Contents Page Introduction NI-700 Overview NI-700 Specifications NetLinx Integrated Master Controller Features NI-700 Specifications NI-700 Specifications (Cont.) NI-700 Port Assignment And Functionality NI-700 On-Board Memory Specifications NI-700 Specifications (Cont.) NI-700 Port Assignments NI-700 On-Board Memory Specifications NI-900 Overview NI-900 Specifications NI-900 Specifications NI-900 Specifications (Cont.) NI-900 Port Assignment And Functionality NI-900 Specifications (Cont.) NI-900 Port Assignments NI-900 On-Board Memory Specifications TimeKeeper Related Documents Page Installation Device:Port:System (D:P:S) Installing into an Equipment Rack 1. 2. 3. 4. 5. Page Connections and Wiring Setting the Configuration DIP Switch (for the Program Port) Baud Rate Settings Program Run Disable (PRD) Mode Working With the Configuration DIP Switch 1. Program Port Connections and Wiring Modes and Front Panel LED Blink Patterns Port Assignments and Functionality The Port Assignments are as follows: AXlink Port and LED Modes and LED Blink Patterns Wiring Guidelines Wiring Length Guidelines Preparing Captive Wires 1. 2. 3. Wiring A Power Connection 1. 2. 3. Using the 4-pin Mini-Phoenix Connector For Data and Power DB9 Device Port: Connections and Wiring IRX-RX Port: Connection and Wiring RS-232/422/485 Device Port Wiring Specifications Input/Output (I/O) Port: Connections and Wiring IR/Serial Port: Connections and Wiring The following table lists the pinouts, signals, and pairing for the Ethernet connector. The IR/Serial connector wiring specifications are listed in the following table. Ethernet/RJ-45 Port: Connections and Wiring IR/Serial Connector Wiring Specifications (per Port) Ethernet LEDs Ethernet Ports Used By the Integrated Controller Ethernet Port Descriptions