AMX NXA-KLB Method B Installing the Flat Lock Bracket, Incoming cables, Security key not included

Incoming cables

FIG. 5 Thread a tie-wrap through the center holes on the Raised Lock Bracket

7.Assemble the Kensington Lock/Security Cable (not included). Refer to the doc- umentation provided by the lock manufacturer for details.

8.Open the Lock to rotate the lock mechanism so that it can be inserted into the slot on the top center of the Raised Lock Bracket (FIG. 6).

Security key (not included)

Kensington Lock/Security Cable assembly (not included)

Raised Lock Bracket

Lock insertion slot

FIG. 6 Lock mechanism and insertion location

Method B: Installing the Flat Lock Bracket

1.If you removed the connectors previously, re-insert them into their proper loca- tions on the touch panel. This ensures that the Flat Bracket will not obstructing any of the connectors on the rear panel.

2.Align the openings on the bottom of the Flat Lock Bracket to the securing locations on the left side of the touch panel connector plate (located under the connector plate cover, as indicated in FIG. 7).

Security key (not included)

Kensington Lock/Security Cable assembly

(not included)

Connector plate cover

Flat Lock Bracket

Keyed-Lock Securing Screws (2)

Base

Base Plate AMX Keyed-Lock screwdriver adapter

FIG. 7 Flat Lock Bracket - Components and Installation

3.Insert two Keyed-Lock Securing Screws into their respective locations (FIG. 7).

4.Use the AMX Keyed-Lock screwdriver adapter to tighten the screws and secure the Flat Lock Bracket to the base plate (FIG. 7).

5.Assemble the Kensington Lock/Security Cable (not included). Refer to the doc- umentation provided by the lock manufacturer for details.

6.Open the Lock to rotate the lock mechanism so that it can be inserted into the opening in the top of the Flat Lock Bracket (FIG. 8).

Security key (not included)

Kensington Lock/Security Cable assembly (not included)

Lock mechanism

Flat Lock Bracket

Lock insertion point

FIG. 8 Lock mechanism and insertion point

AMX Corporation reserves the right to alter specifications without notice at any time.	93-2259-10	REV: A
For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
036-004-2870 4/05 ©2005

AMX Corporation. All rights reserved. The AMX logo is a trademark of AMX Corporation. AMX reserves the right to alter specifications without notice at any time.

3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com