AMX R-3 manual Irmode #, Jst, Numd, Reboot

Programming The Mio R-3

Serial Commands (Cont.)

IRMODE #	Syntax:
Sets the IR transmission	IRMODE #
frequency to either 38 or	Variables:
455KHz
	• <mode> =
	38 - IR only, 38KHz
	455 - IR only, 455KHz
	ZIG - ZigBee only
	ZIG38 - ZigBee + IR 38KHz
	ZIG455 - ZigBee + IR 455KHz
	Example:
	IRMODE 455
	Sets the IR transmission frequency to 455 KHz.
	IRMODE ZIG
	Sets the IR to disabled and communications to only use ZigBee.
	IRMODE ZIG38
	Sets the IR transmission frequency to 38KHz and configures for simultaneous
	transmission on ZigBee.
^JST	Syntax:
Set text alignment using a	"'^JST-<variable text address range>,<new text
numeric keypad layout for	alignment>'"
those buttons with a defined	Variable:
address range
	• variable text address range = 1; the address range corresponds to the
	dynamic line number-only one line is supported on this device.
	• new text alignment = Value of 1 - 9 corresponds to the following locations:
	1, 4 or 7 = Left
	2, 5 or 8 = Center
	3, 6 or 9 = Right
	Example:
	SEND_COMMAND Panel,"'^JST-1,1'"
	Sets the text alignment to the left side of the LCD button
	Note: There is no vertical alignment.
NUMD	Syntax:
Sets the number of devices to	NUMD <numberOfDevices>
be controlled by the remote	Example:
	NUMD 1
	Sets the remote to control only one device.
REBOOT	Syntax:
Reboots the remote	REBOOT
	Example:
	REBOOT
	Reboots the remote

Mio Modero R-3 Remote 17