AMX specifications Installation Sheet, RDM-SWMSwitch Module 2400 W

Installation Sheet

RDM-SWMSwitch Module 2400 W

The RDM-SWM Switch Module is a 2400 W general purpose relay module built for economical switching of incandescent lamps, low-voltage transformers, switched fans and electrical outlets. It is designed for use with the RDA series of enclosures, in an AMX Lighting™ modular digital dimming system. The RDM-SWM uses a positive air gap type relay. This module's 120, 240, and 277 VAC ratings are CE, UL, and C-UL approved.

Specifications

• Dimensions (HW): 10.00" x 2.75" (25.40 cm x 6.99 cm)

• Non-phase dependant

• Use wires rated at 75°C (167°F)

• Torque terminals to 7 in-lbs. (0.8 N/M)

• Max. wire size: 10 AWG (4 mm²)

• Wire stripping length: 0.28" (7 mm)

Mounting points

Line in (hot)

Load out

High-voltage connections

• Weight: 0.5 lbs. (0.227 kg)
•	BTU/hr: 5
•	Control current: 85 mA @ 12 VDC

Caution: Pre-Installation Notes

• All Class 1 wiring must be connected to proper terminals.

• All control wiring must be connected to proper terminals.

• Disconnect power while installing or connecting the unit.

• Keep top and bottom air vents clear at all times.

• Test loads for shorts before connecting.

• Use low-voltage wires with a 300 volt rating or greater.

• Use field installed copper conductors.

Relay A

Low-voltage control wiring: 4-pin connector to AMX Lighting master controller

• All electrical ratings are for continuous duty.
•	For indoor use only.
•	This module may require extra power from the AXlink connection or an
	external power supply connected to the control card.

Connecting the RDM-SWM to the AMX Lighting Master

Pin 4 (GND)

Pin 3 (RLY)

Pin 2 (DIM)

Pin 1 (+12 V)

RDM-SWM 4-pin module connector

3(-)

1 (+)

4-pin plug from RDM series module

NOTE: The 4-pin plugs from the module connector to

the 4-pin connector on the master (black plug cover facing up).

FIG. 1 RDM-SWM Switch Module

FIG. 2 RDM-SWM connections

RDM-SWM UL and C-UL Ratings

•General purpose: 2400 W

•Resistive: 2400 W

•Ballast: 2400 W

•Motor: 277 VAC, 1 hp

Suggested Switched Loads

•Incandescent

•Low-voltage

•Motors

•Switched outlets

•Fluorescent