AMX Installing The VSS2, Connecting the Wiring, Video 1 and 2 connectors, Sense out connector

Installing The VSS2

Installing The VSS2

You can install the VSS2 on any flat surface that has unobstructed access to the rear panel connectors. The following describes how to set up and install the VSS2.

Connecting the Wiring

You can connect up to two video devices to the RCA plug-in connectors on the VSS2. Once attached, you can connect up to two external sensing devices, a television manager, or a AMX control system to the four-pin Sense out connector on the rear panel. The following describes how to connect your video devices, external equipment, and the 12 VDC power supply

Video 1 and 2 connectors

FIG. 4 shows how to connect your video devices to the Video 1 and 2 RCA plug-in connectors on the rear panel.

Video	OUT	IN
Source 1
Video	OUT	IN
Source 2

VSS2

Video

1

Video

2

OUT

OUT

Video

IN Destination

1

Video

IN Destination

2

FIG. 4 Video RCA connector diagram

Sense out connector

FIG. 5 shows how to connect two external video-sensing devices.

	SENSE2	Sense 2
Sense out	GND2
connector	SENSE1	Sense 1
	GND1

FIG. 5 External video sensing wiring diagram

VSS2 Video Sync Sensor 5