AMX VTM-D15/A - page 18

Installation and Wiring
14 VTM-D15/A 15" MultiMedia Touch Panel Systems
6. Verify that the folds/latches at the bottom of the bracket are securely located within the fixing
holes.
7. Align the screws holes (on the rear of the panel) with the openings at the top of the bracket
(FIG. 10).
8. Insert the two screws into their respective locations and begin tightening until the screws are
securely fastened into the panel.
9. Verify that the panel is securely connected to the Table Top Bracket at both ends.
FIG. 9 Fixing holes on each side of pull-out flap
FIG. 10 Attaching the Table Top Bracket to the rear of the panel
Fixing Holes
Table Top
Display Stand
Support Bracket
Fixing Holes
Screws holes
Screws (2)
Fixing holes