RS2042 EN 2/24/04 9:43 AM Page 7
Getting Started
Unpacking the system
You should have the following:
•one main unit (with 2 main speakers);
•one remote control;
•one AM loop antenna;
•one user’s guide;
•one safety leaflet;
•Owner registration Card.
Back View
R | L | AUX IN | 4 |
|
|
|
| ||
R | L |
| 1 | 2 |
+ | + | Ω |
|
|
|
| 6 | 3 |
|
|
| SPEAKERS |
| |
|
|
| AM LOOP | FM ANTENNA |
|
|
|
| |
|
| MAIN |
|
|
1.AM Loop antenna Jacks.
2.FM Pigtail Antenna.
3.Main Speaker Jacks.
4.Aux In.
Using the FM and AM Antennas
Before you use your audio system, you’ll want to make sure both the FM and AM antennas are positioned properly. Uncoil the FM antenna at the back of the unit, making sure it is fully extended (you may even want to tape it to the wall behind the unit if possible. The higher the better.) You’ll also need to connect the AM antenna loop to the back of the unit if you listen to AM stations. Rotate the AM loop antenna for better reception.
Connecting the Speakers | EN |
Each speaker has a black (negative) and a red (positive) jack. When connecting the speakers, match the red wires to the red jacks and the black wires to the black jacks.
Speaker Wire Connection
| Push Speaker terminal tab | Release tab to lock wire in |
| down to insert wire. | the terminal. |
NOTE: Make sure the insulation is completely removed from the ends of the speaker wires at all connection points.
Installation
To ensure sufficient ventilation, keep the spacings shown below free from other surfaces:
Front View | 4 inches |
4 inches | 4 inches |
| 5 DISC CHANGER |
Side View | 4 inches |
2 |
|
inches |
|
2
