Lochinvar SCH-I-O Flat tile hook #SRM20005, 8 Install Rafter Anchor, 9 Grind Tile if necessary

SCH Collectors Installation & Operation Manual

3 Roof Attachment Installation

Figure 3-8Install Rafter Anchor

COLLECTOR SUBSTRUCTURE

HEX BOLT

INSTALL WASHER

AND WOOD SCREW

SPACER PLATE (IF NECESSARY)

RAFTER ANCHOR

Flat tile hook #SRM20005

The flat tile hook is only used for parallel installation on plain tiled roofs (generally steep roofs with a pitch of over 30°), the hooked ends are hung over the roof battens and screwed in place, an inclined collector installation is not possible here.

Unpacking and checking parts

When unpacking the system, check the model names of the components of each system and check to be sure you have the correct number of parts (see FIG. 3-10).

Figure 3-9Grind Tile (if necessary)

IF NECESSARY, GRIND

THE TILE FOR A BETTER

FIT

11.Slide the square disk onto the hex bolt (see FIG. 3-8).

12.Install the hex bolt with square disk attached into the opening of the rafter anchor as shown in FIG. 3-8.

Note: Do not tighten hex bolt until ready to install on the collector substructure.

13.Thread the hex nut (M8) and washer (M8) onto the bottom of the hex bolt installed in Step 12.

14.Repeat Steps 4 - 13 until installation is complete.

15.Replace tiles removed in Step 4.

Install hex bolt onto collector substructure (reference Section 4 - Collector Installation)

Figure 3-10Kit #SRM20005 - Flat Tile Hook Kit Components

FLAT TILE HOOK (1X)

METAL SHEET (1X)

HEX NUT (M8) (1X)

SQUARE DISK (1X)

HEX BOLT (M8) (1X)

WASHER (M8) (1X)

WOOD SCREW (1X)

NAIL (3X)

16