Lochinvar SCH-I-O operation manual 1 Connection Diagram, Introduction, Dismantling and Disposal

SCH Collectors Installation & Operation Manual

1 Introduction

NOTICE	• Check the materials for any damage
	sustainedintransportanddescribeany
	damage in writing on the packing slip
	where necessary. This is important to
	process any needed freight or delivery
	damage claims.

•Carefully read through the relevant installation instructions before starting the installation and follow each step.

•Use only the original mounting components.

•Stainless steel screws may not be used again once they have been removed (because of the possibility of breaking).

•Any conversion or modification of the Lochinvar/TiSun product not expressly approved in writing by the manufacturer shall void the warranty.

•No liability can be accepted for damage resulting from failure to observe the installation instructions.

￿WARNING Only authorized solar companies familiar with our products may handle them.

There is a risk of injury when handling ￿ WARNING collectors and mounting accessories as

these have sharp edges.

￿WARNING A properly sized expansion tank must be used to avoid damage to the Solar Thermal

System.

￿WARNING If copper pipe is being used, all joints MUST BE brazed, no soldering allowed.

Figure 1-1Connection Diagram

￿WARNING

￿WARNING

￿WARNING

The collector becomes very hot in the sunlight. There is a risk of burn.

Comply with all safety regulations and applicable OSHA requirements.

Check the load bearing capacity and stability of the substructure onto which the collector is to be installed and will need to be accessed during the installation process.

Dismantling and Disposal

•The units are dismantled in the reverse sequence of installation.

•The roofing shall be properly sealed after the mounting brackets have been removed.

•Materials shall be disposed of in an environmentally conscious manner.

6