Lochinvar SCH-I-O Flange plate shingle raised #SRM20008, Install flange plate shingle raised

SCH Collectors Installation & Operation Manual

3 Roof Attachment Installation

Flange plate shingle (raised) #SRM20008

The raised flange shingle plate is used for inclined installations on asphalt and elastomer roofs; also suitable for flat roofs.

Install flange plate shingle (raised)

1.	Determine roof type. Inspect the structural integrity of
	the roof and the durability of the roof materials.
2.	Determine the number of collectors needed for the

￿CAUTION

•The plates must be screwed into a member capable of bearing the required static load (generally rafters or concrete).

•Once installed, the panels must be sealed to the roof sheet material (FIG. 3-28), and only then can the collector be fitted.

	installation and the number of required attachments
	from Table 3B or 3C on page 11.
3.	Determine collector connection points (spacing).
	Measure the spacing of the rafters or trusses to confirm
	the dimensions and prepare for the system layout
	(reference the Roof Attachment Spacing Section on
	page 12).
4.	Caulk (field supplied) around the perimeter of the flange

Unpacking and checking parts

When unpacking the system, check the model names of the components of each system and check to be sure you have the correct number of parts (see FIG. 3-25).

Figure 3-25Kit #SRM20008 - Flange Plate (Raised) Kit Components

FLANGE PLATE RAISED (1X)

SCREW (M10) (4X)

SCREW (M6) (4X)

SQUARE DISK (1X)

HEX NUT (M8) (1X)

HEX BOLT (M8) (1X)

	plate (FIG. 3-26).
5.	Using the flange plate as a template, place the flange plate
	on the roof and drill four (4) 6 mm holes as shown in
	FIG. 3-27. Install the larger screws provided in the kit
	into the 6mm holes securing the flange plate to the roof
	(caulk around screws before tightening).
6.	Install the four (4) remaining smaller screws in the
	perimeter of the flange plate as shown in FIG. 3-27 (caulk
	around screws before tightening).
7.	Cover the flange plate with roofing material, sealing it to
	the roof (FIG. 3-28).

Figure 3-26Caulk Around Perimeter of Flange Plate

	CAULK AROUND
~ Ø 5 mm	THE PERIMETER
	OF THE FLANGE PLATE

WASHER (M8) (1X)

22