Analog Devices AD604 AD604, ABSOLUTE MAXIMUM RATINGS

AD604

Rev. E | Page 5 of 32

ABSOLUTE MAXIMUM RATINGS

Table 2.

Parameter1, 2Rating

Supply Voltage ±VS

Pin 17 to Pin 20 (with Pin 16, Pin 22 = 0 V) ±6.5 V

Input Voltages

Pin 1, Pin 2, Pin 11, Pin 12 VPOS/2 ± 2 V

continuous

Pin 4, Pin 9 ±2 V

Pin 5, Pin 8 VPOS, VNEG

Pin 6, Pin 7, Pin 13, Pin 14, Pin 23, Pin 24 VPOS, 0 V

Internal Power Dissipation

PDIP (N) 2.2 W

SOIC (RW) 1.7 W

SSOP (RS) 1.1 W

Operating Temperature Range −40°C to +85°C

Storage Temperature Range −65°C to +150°C

Lead Temperature, Soldering 60 sec 300°C

θJA3

AD604AN 105°C/W

AD604AR 73°C/W

AD604ARS 112°C/W

θJC3

AD604AN 35°C/W

AD604AR 38°C/W

AD604ARS 34°C/W

1 Pin 1, Pin 2, Pin 11 to Pin 14, Pin 23, and Pin 24 are part of a single-supply

circuit. The part is likely to suffer damage if any of these pins are accidentally

connected to VN.

2 When driven from an external low impedance source.

3 Using MIL-STD-883 test method G43-87 with a 1S (2-layer) test board.

Stresses above those listed under Absolute Maximum Ratings

may cause permanent damage to the device. This is a stress

rating only; functional operat ion of the device at these or any

other conditions above those indicated in the operational

section of this specification is not implied. Exposure to absolute

maximum rating conditions for extended periods may affect

device reliability.

ESD CAUTION

Contents

Main Dual, Ultralow Noise Variable Gain Amplifier FEATURES APPLICATIONS FUNCTIONAL BLOCK DIAGRAM GENERAL DESCRIPTION AD604 TABLE OF CONTENTS AD604 SPECIFICATIONS AD604 AD604 ABSOLUTE MAXIMUM RATINGS ESD CAUTION AD604 PIN CONFIGURATION AND FUNCTION DESCRIPTIONS Table 3. Pin Function Descriptions AD604 Figure 8. Gain Error vs. VGN at Different Frequencies Figure 5. Gain vs. VGN for Different Gain Scalings GAIN SCALING (dB/V) Figure 9. Gain Error vs. VGN for Two Gain Scaling Values Figure 14. Output Referred Noise vs. VGN for Three Temperatures Figure 11. Gain Match; VGN1 = VGN2 = 2.50 V PERCENTAGE Figure 15. Input Referred Noise vs. VGN Figure 20. Noise Figure vs. VGN 00.40.81.21.62.02.42.8 0 2 Rev. E | Page 10 of 3 Figure 21. Harmonic Distortion vs. Frequency Figure 26. Third-Order Intercept vs. VGN 100ns/DIV Figure 32. DSX Common-Mode Rejection Ratio vs. Frequency CROSSTALK (dB) 100ns/DIV INPUT IMPEDANCE () DELAY (ns) Figure 34. Input Bias Current vs. Temperature SUPPLY CURRENT (mA) AD604 THEORY OF OPERATION PREAMPLIFIER () () [] () DIFFERENTIAL LADDER (ATTENUATOR) AC COUPLING GAIN CONTROL INTERFACE ACTIVE FEEDBACK AMPLIFIER (FIXED-GAIN AMP) Page AD604 APPLICATIONS INFORMATION ULTRALOW NOISE AGC AMPLIFIER WITH 82 dB TO 96 dB GAIN RANGE Page Rev. E | Page 21 of 3 500mV 100 90 80 70 60 50 40 30 20 10 0 10 ULTRALOW NOISE, DIFFERENTIAL INPUT- DIFFERENTIAL OUTPUT VGA the signal amplitude compared with when they are driven single-ended. AD604 Figure 50. Ultralow Noise, Differential Input-Differential Output VGA 20ns20mV MEDICAL ULTRASOUND TGC DRIVING THE AD9050, A 10-BIT, 40 MSPS ADC AD604 AD9050 AD7226 AD9631 AD604 Figure 53. Basic Test Board AD604 Figure 54. Setup for Gain Measurements AD604 EVALUATION BOARD DSX INPUT CONNECTIONS Differential DSX Inputs USING THE PREAMPLIFIER PREAMPLIFIER GAIN OUTPUTS DC OPERATING CONDITIONS EVALUATION BOARD ARTWORK AND SCHEMATIC AD604 Figure 61. Evaluation Board Schematic Table 6. Bill of Materials 40 MHz dual low noise VGA AD604 OUTLINE DIMENSIONS ORDERING GUIDE