BASIC SYSTEM OPERATION
NOTE: Fully Charge Batteries Before First Use!
1.Before turning your system on: Set all Input Level Controls to minimum & Tones Controls to the flat or middle setting
2.Plug in a wired microphone (MIC IN or BALANCED INPUT jacks) and/or a separate audio source
3.Set Power Switch to “ON”, a red LED near switch will light up
4.Adjust Level Controls for active Input Jacks to desired volume
5.Speech/Projection Button: ON for speech applications or OFF for music & indoor use
6.Adjust sound quality w/ the BASS & TREBLE Tone Controls
SOUND SYSTEM ACCESSORIES
Unpowered dual function companion speaker (speaker cable not included)
50’ speaker cable, use to connect the
100’ speaker cable, use to connect the
Adjustable stand made of black, anodized aluminum
For travel or storage - holds one Xtreme sound system & accessories
Soft case w/ wheels & collapsible handle, holds Xtreme, stand & accessories
MIC-90 - Handheld Wired Microphone
Anchor’s dynamic, balanced, low impedance microphone w/ unidirectional
ANCHOR WIRELESS - 16 CHANNEL UHF
Works w/ hands free microphones (mic not included - see below)
Lightweight,
Hands free
Lightweight,
4
WIRELESS RECEIVER CONTROLS
(see page 6)
SPEECH/PROJECTION BUTTON
(see instructions below)
TONE CONTROLS - BASS/TREBLE
LINE IN - INPUT JACK
Unbalanced 1/4” - high impedance, for any
MIC IN - INPUT JACK
Balanced XLR - low impedance input for balanced mics, +12VDC power for
CONDENSER MIC POWER
BALANCED INPUT - JACK (see “Balanced XLR” below)
INPUT LEVEL BUTTON
POWER SWITCH
XTREME SOUND SYSTEM
CONTROL PANEL
Model Shown:
BALANCED XLR INPUT
The balanced XLR, low impedance input jack can be used for either a balanced line level input or a balanced microphone input. The Input Level & Condenser Mic Power features are user selectable.
Condenser Mic Power Button: For condenser microphones, set the Condenser Mic Power button to “ON” (button in); the “ON” setting supplies +12VDC at the input. Setting the button to “OFF” (button out) supplies 0V for all other input applications.
Input Level Button: For a microphone level input set the Input Level button to “MIC” (button in). For line level sources set the Input Level button to “LINE“ (button out).
CD PLAYER CONTROLS (see page 6)
CD PLAYER VOLUME CONTROL
LINE OUT - OUTPUT JACK
Balanced 1/4” - provides a combined output of all active system inputs Record your presentation or connect to another powered sound system
This output is post source level; any volume fluctuations for a specific input will affect this output signal level
COMPANION SPEAKER OUT
Biamped output jack (separate amplifier for the high & low frequencies) intended for use with the
INPUT LEVEL CONTROLS
AC POWER CORD INLET
FUSE
SPEECH/PROJECTION BUTTON
Allows you to customize the sound output of your Xtreme sound system for different applications:
Speech Projection Off (button out): A flat, full range frequency response for music or indoor voice applications.
Speech Projection On (button in): Frequencies in the vocal range are boosted for added clarity and efficient sound projection. Use this setting for outdoor functions, large crowds and speech applications.
