A MESSAGE FROM THE OWNER
OPERATING THE WIRELESS MICROPHONE/TRANSMITTER
Thank you for choosing an Anchor Audio portable sound system. Our products incorporate
I hope you’ll take a few minutes to review this manual. We’ve incorporated several unique features into our products, and your knowledge of how to use them will enhance the performance and your enjoyment of the system.
David Jacobs, President
on behalf of all Anchor Employees
GETTING STARTED
CHANNEL SELECTION - HANDHELD TRANSMITTER
1.Unscrew battery cover on bottom of microphone
2.Set the CHANNEL SELECTOR dial to match the channel setting of your receiver
3.Replace battery cover and tighten firmly
CHANNEL SELECTION - BODY-PACK TRANSMITTER
1.The channel selection dial is located on the side of the transmitter
2.Set the CHANNEL selection dial to match the channel setting of the receiver
Please check your new unit carefully for any damage which may have occurred during shipment. Each Anchor product is carefully inspected at the factory and packed in specially designed boxes for safe transport.
Notify the freight carrier immediately of any damage to the shipping box or product. Repack the unit in the original box and wait for inspection by the carrier’s claim agent. Notify your dealer of the pending freight claim.
NOTE: All damage claims must be made with freight carrier!
RETURNING SYSTEMS FOR SERVICE OR REPAIR
For service or repair, please contact the dealer you purchased your system from or Anchor Audio Customer Service at (888)
IMPORTANT: Save the shipping box & packing materials,
they were specially designed to ship your unit!
WARRANTY REGISTRATION
Visit our website at www.anchoraudio.com and select “Warranty Registration”. Complete the online form to activate the
SETTING UP YOUR XTREME SOUND SYSTEM
We recommend placing your sound system between the audience and the presenter, facing the audience and raised above their heads using a speaker stand or table. This benefits listeners in the rear of the crowd, minimizes the risk of overpowering those in the front and helps prevent feedback by keeping microphone users behind the sound system.
SINGLE SYSTEM PLACEMENT
Place your unit along the least trafficked aisle pointing towards the center of the audience.
MULTIPLE SYSTEM PLACEMENT
Place units along aisles pointing just off the audience center line, over the crowds head. With the sound system placed properly it should provide sufficient coverage.
2 | NOTE: The | |
sound system in a different room or a separate recording device. | ||
| ||
|
|
NOTE: When using dual wireless, each microphone must be set to a different channel!
USING YOUR WIRELESS MICROPHONES
After you have set the transmitter channel (see above) you are ready to use your wireless microphone:
1. | 3. | Turn the Xtreme power switch to ON | |
| plug into the transmitter jack marked MIC | 4. | The RX indicators will light (only one indicator |
|
| ||
2. | Turn the transmitter power switch to ON |
| will light at a time) when the wireless signal is |
| (The red LED will flash when the mic is turned on. |
| being transmitted and received |
| If the red LED stays on, the battery is low) |
|
|
CAUTION: Harmful feedback may occur when walking in front of a sound system or speaker with a wireless microphone. Always point microphone away from speakers!
REPLACE BATTERY - HANDHELD TRANSMITTER | REPLACE BATTERY - | ||
1. | Unscrew battery cover on bottom of microphone | 1. | Slide open battery cover on front of transmitter |
2. | Replace old batteries with 2 fresh size ‘AA’ | 2. | Replace old batteries with 2 fresh size ‘AA’ |
| alkaline batteries |
| alkaline batteries |
3. | Replace battery cover and tighten firmly | 3. | Replace battery cover by sliding firmly into place |
NOTE: Transmitter power must be OFF when changing batteries! | 7 |
|
