16
AWGN waveform pattern
Standard

AWGN waveform pattern:

The Additive White Gaussian Noise (AWGN) waveform pat-
terns listed in the table below are provided on the MG3700A
internal hard disk.
The signals for testing the receiver/transmitter of a terminal or
module can be output by selecting one of these AWGN
waveform patterns.
Example of selecting a waveform pattern
Waveform pattern MAX peak/RMS 3dB bandwidth In-band power Evaluation
ratio (MHz) conversion ratio (dB)
AWGN_3_84MHz_x2 >12 dB 7.68 3.01 Added with the W-CDMA UL signal to
perform a dynamic range test.
AWGN_3_84MHz_x1_5 >12 dB 5.76 1.76 Added with the W-CDMA UL signal to
perform a dynamic range test.
Added with the reverse signals of
AWGN_1.23MHz_x2 >12 dB 2.46 3.01 CDMA2000 or CDMA2000 1xEV-DO to
perform a dynamic range test.
Added with the reverse signals of
AWGN_1.23MHz_x1_5 >12 dB 3.69 1.76 CDMA2000 or CDMA2000 1xEV-DO to
perform a dynamic range test.
In-band power conversion ratio is the ratio of the system bandwidth of each communication system to the total power of the MG3700Aoutput measured with a
power meter or another equivalent device.
AWGNWGN
AWGN
AWGN band width
System band width
Wanted signal
In-band
AWGN
power
In-band AWGN power
*MX370X_E_050127 1/28/05 8:51 AM Page 16