CONNECTING THE IEEE 1394 (FIREWIRE®, I.LINK®) PORT
You will find a single
Note: Please check your motherboard manual for your IEEE 1394 header pin layout and make sure it matches the attached table. If you intend to connect the front FireWire port to an IEEE 1394
|
|
| Standard Pin Assignment for IEEE 1394 Connector | |||
1 | 2 |
|
|
|
|
|
Pin |
| Signal Names | Pin | Signal Names | ||
|
|
| ||||
|
| 1 |
| TPA + | 2 | TPA - |
|
| 3 |
| Ground | 4 | Ground |
|
| 5 |
| TPB + | 6 | TPB - |
|
| 7 |
| +12V (Fused) | 8 | +12V (Fused) |
9 | 10 | 9 |
| Key (No pin) | 10 | Ground |
CONNECTING THE AUDIO PORTS
Locate the internal audio connectors from your motherboard or sound card. Consult your mother- board or sound card manual for the
1.Microphone Signal Pin: Connect the
2.Microphone Power: Connect the
3.Ground Pin: Connect the GROUND connector to this pin.
4.Front Right Speaker Out Pin: Connect the
5.Front Right Speaker Out Pin: Connect the
6.Rear Right Speaker Out Pin: Connect the
7.Rear Left Speaker Out Pin: Connect
Note: If your motherboard is not equipped with REAR SPEAKER output, it is not necessary to use the
DRIVE INSTALLATION
Minuet incorporates a
1.Before installing the external drives, remove the external drive bay covers.
a.To remove the external 5.25” drive bay cover, face the front of the case and use your left hand thumb to press firmly on the LEFT or outside edge of the left bay cover to release it.
(See picture 3)
b.To remove the external 3.5” drive bay cover, face the front of the case and use your right hand thumb to press firmly on the RIGHT or outside edge of the right bay cover to release it.
(See picture 4)
4