Cooling System, Section | Antec ONE S3 guide

Section 4

Cooling System

One / One S / One S3 User Manual

19

Image 19

Antec ONE S3 user manual Cooling System, Section, One / One S / One S3 User Manual

Contents

User Manual One / One S / One S3 Disclaimer One / One S / One S3 User Manual Section 3 Front I/O Ports Table of ContentsSection 2 Hardware Installation Section 1 Introduction Section IntroductionOne / One S / One S3 User Manual Getting to Know Your Chassis Chassis Specifications Included Screws Hardware Installation Removing the Side Panels and Front Bezel Setting Up Motherboard Installation Power Supply Installation Installing KUHLER H2O Liquid Coolers External 5.25” Device Installation Secure your drive with the provided 2.5” screws Internal 2.5” Device Installationwhen sliding it in Align your drive’s holes with the drive bay holes Cable Management Internal 3.5” Device Installation Front I/O Ports USB 2.0 pin assignments USB PortsAC’97 / HD Audio Ports Align the connector properly to prevent damage to your motherboard Note Polarity positive and negative does not matter for switches Power Switch / Reset Switch / Hard Disk Drive LED Connectors Front panel headers Rewiring Motherboard Header Connections Cooling System 120 mm Single Speed Fan Specifications Included Fans Front intake 120 mm fan Optional FansSide 120 mm fan Bottom 120/140 mm fan PSU Air FilterRear 120 mm fan - One S / One S3 only Europe Antec, IncAntec Europe B.V Technical Support