Hardware Installation, Section | Antec ONE S3 specs

Section 2

Hardware Installation

One / One S / One S3 User Manual

8

Image 8

Antec ONE S3 user manual Hardware Installation, Section, One / One S / One S3 User Manual

Contents

One / One S / One S3 User Manual One / One S / One S3 User Manual Disclaimer Table of Contents Section 2 Hardware InstallationSection 1 Introduction Section 3 Front I/O Ports One / One S / One S3 User Manual IntroductionSection Getting to Know Your Chassis Chassis Specifications Included Screws Hardware Installation Setting Up Removing the Side Panels and Front Bezel Motherboard Installation Installing KUHLER H2O Liquid Coolers Power Supply Installation External 5.25” Device Installation Internal 2.5” Device Installation when sliding it inAlign your drive’s holes with the drive bay holes Secure your drive with the provided 2.5” screws Internal 3.5” Device Installation Cable Management Front I/O Ports USB Ports AC’97 / HD Audio PortsAlign the connector properly to prevent damage to your motherboard USB 2.0 pin assignments Power Switch / Reset Switch / Hard Disk Drive LED Connectors Note Polarity positive and negative does not matter for switches Rewiring Motherboard Header Connections Front panel headers Cooling System Included Fans 120 mm Single Speed Fan Specifications Side 120 mm fan Optional FansFront intake 120 mm fan Rear 120 mm fan - One S / One S3 only PSU Air FilterBottom 120/140 mm fan Antec, Inc Antec Europe B.VTechnical Support Europe