3.Take two pieces of the Tension Clips and mount them onto the sides of the 5.25" device. Make sure the metal portion is angled on the outside and facing forward.
4.Slide the device into the drive bay until you hear a clip.
5.Mount the other devices accordingly.
6.Connect a large
IDE Cable Connection
This is for IDE devices only.
1.After you have connected the devices to the power supply, you need to connect the IDE cables between the devices and the motherboard.
2.For hard drives and
For floppy drives, use the
3.The side that attaches to devices should be the side that has 2 connectors. This will enable you to connect another device if you wish.
4.Connect the far end of the cable to your motherboard on the IDE port.
Fan Installation
The case comes with two 80mm fans installed in the rear of the case. The fans are installed such that the air is blowing out of the case. The case has 3 optional 80mm fan mounts in the front (two of them located inside the drive cages) and 1 optional 92mm fan mount in the rear, in addition to the 2 standard 80mm rear mounted fans.
Note: Antec Cooling Fans blow in the direction that the Antec logo is facing.
1.Pull the quick release lever towards the rear of the case and release the drive cage.
2.Drop the fan into the cage and push it in until it clips in. No screws are needed.
3Connect the
3 | 4 |