5.Slide the HDD cage back into the case and fasten it with thumbscrews.
6.Connect the appropriate conneector(s) from the power supply to the device(s). Leave some sllack in the connections so that you can easily access the fan fiilters for cleaning.
7.There is a 120 mm fan
Note: There is a middle fan bracket
2.6External 5.25” Device Insstallation
Note: The HDD cages each occupy three consecutive drive bays, and will block installation of larger devices such as optical drives, so please plan ahead before installing your drives.
1.Remove both side panels per the instructions in Setting Up.
2.Remove the screws fastening the appropriate metal drive bay cover(s) to the sides of the case.
3.Remove the cover(s).
4.If necessary, please remove the HDD cage that is
5.Slide the 5.25” device into thee bay from the front of the case.
6. Fasten the drive using the screews that came with your | drive. |
7.Connect the appropriate power and interface connectors from the power supply and motherboard to the device. Make sure that you leave somme slack in the connections so that you can easily access the fan filters for cleaning.
8.Mount the other devices accoordingly.
2.7Internal 2.5” Device Installation
At the bottom of your case, there are mounting holes designed to support one 2.5” SSD device.
1.Locate the plastic bag labeled “For 2.5 HDD” and remove the 4 silicone grommets.
2.Install the grommets into the four holes at the base of the case at the bottom of the drive bay areea as shown. You should install them with the thick part of the grommmets facing the inside of the case.
3.Lay the Twelve Hundred V3 on its side, and hold the drive in place on top of the grommets.
4.Secure the device to the case with the screws provided, tightening the screws with your fingers first, and then the screwdriver.
5.Connect the appropriate poower and data cables to your device
6
