LED Indications

The DUAL 2722 has two sets of two LEDs (one red, one green) and one green status LED in the center. The green status LED indicates: Steady green – line voltage is present; Off – line voltage not present..

The red and green charge status LED’s indicate the charging status of the battery. The following table identifies all of the LED indications and their meaning. Please note that the right side charge position will not illuminate the red or green LEDs when power is being drawn from the 4 pin XLR, unless a battery is present.

LED INDICATION

MEANING

Alternating

Indicates that the DUAL 2722 is evaluating the battery and/or

Red & Green

communicating with a DIGITAL battery, loading battery

 

parameters and determining the appropriate charge routine. A

 

low voltage (<11V) battery will cause this indication to

 

continue until the battery reaches safe charging voltage.

Steady Red

Indicates that the battery is being held by the DUAL 2722 to

 

stabilize an out-of-range temperature condition, or camera supply

 

is in use (right side only).

 

Or it can also indicate if a non-Anton/Bauer Logic Series battery

 

has been mounted on the charger. These batteries cannot identify

 

themselves to the DUAL 2722 and will not be charged.

Flashing Red

Indicates that the battery is currently under Stage One charge.

 

 

Flashing Green

Indicates that the battery is currently under Stage Two charge.

(slow rate)

 

Flashing Green

Indicates a fully charged DIGITAL battery is placed on the

(fast rate)

charger and a FUL cutoff condition cannot be met. The charger

 

is VERIFYING that the battery is in a full charge condition.

Steady Green

Indicates that the battery is READY and in Stage Three Lifesaver

 

mode.

Red/Green Charge Status LED

Green Status LED

5

Page 8
Image 8
Anton/Bauer DUAL 2722 owner manual LED Indications, LED Indication Meaning