AOpen AK77-600N Front Panel Connector, SPWR, ACPI LED, Suspend Type

AK77-600N OOnnlliinnee MMaannuuaall

Front Panel Connector

Attach the power LED, speaker, power and reset switch connectors to the corresponding pins. If you enable “Suspend Mode” item in BIOS Setup, the ACPI & Power LED will keep flashing while the system is in suspend mode.

Locate the power switch cable from your ATX housing. It is 2-pin female connector from the housing front panel. Plug this connector to the soft-power switch connector marked SPWR.

	Suspend Type			ACPI LED
Power on Suspend (S1)			Blinking between green and red
Suspend to RAM (S3) or Suspend to Disk (S4)			Blinking between green and red
	1		NC	1
	Power Switch			SPWR
			NC	GND
			+5V	ACPILED-
IDE LED	ACPI & Power LED	IDE LED		GND
		IDE LED		ACPILED+
			+5V	NC
			+5V	NC
SPEAKER			GND	GND
			NC	RESET
	RESET
		SPEAKER		GND

38