APC 1250, 2000, 900

Page 39

Notes

Contents

Main Smart-UPS Important safety instructions! VCCI-1* Radio Frequency Interference Table of contents 1.0 Introduction 1.1 Overview Line interactive UPS block diagram 1.0 Introduction 1.2 SmartBoost 1.3 Battery replacement indicators and test 1.4 Remote interfaces 1.5 Extended capabilities 2.0 Safety ! ENGLISH Caution! CAUTION ! 2.0 Scurit ! FRANAIS Attention! ATTENTION! 2.0 Sicherheit ! DEUTSCH Vorsicht! VORSICHT! ESPAOL 2.0 Seguridad ! Atencion! ATENCION! 3.1 900VA and 1250VA models - 100, 120 Vac versions Rear view Front view 3.2 900VA and 1250VA models - 220/230/240 Vac version Rear view Front view 3.3 2000VA model - 100, 120 Vac versions Front view Rear view 3.4 2000VA model - 120 Vac versions options 3.5 2000VA model - 208 Vac version and options Standard Option -1 Option -2 3.6 2000VA model - 220/230/240 Vac version Rear viewFront view 4.1 Receiving inspection 4.2 Placement 4.3 Connect battery pack - 2000VA model only Note: Use only factory supplied or authorized battery packs! 4.4 Connect UPS to service and enable 4.4 Connect UPS to service and enable - continued 4.5 Plug loads into UPS 4.6 Check Site Wiring Fault indicator - 100, 120 Vac versions 4.7 Switch on load equipment 4.8 Switch on the UPS 5.1 Display features 5.2 Battery capacity bar graph 5.3 Output power bar graph 5.4 Line voltage bar graph 5.5 Audible alarm Note: Option switches may be thrown at any time and take effect immediately. 5.6 Option switches 5.6 Option switches - continued 5.7 Extended capabilities Page 5.7 Extended capabilities - continued 6.0 UPS Monitoring 6.1 Overview 6.2 Interface Kits 6.3 PowerChute Software 6.0 UPS Monitoring 6.4 Computer interface port Caution ! ENGLISH CAUTION ! FRANAIS 7.0 Difficult Attention ! ATTENTION! DEUTSCH 7.0 Schwierigkeit Vorsicht ! VORSICHT! ESPAOL 7.0 Dificultad Cuidado! CUIDADO! Page 32 7.1 Troubleshooting chart PROBLEM POSSIBLE CAUSE ACTION TO TAKE 7.2 Battery replacement check Note: Please see the battery cautions at the beginning of this section. 7.3 Obtaining Service 8.0 Storing the UPS 9.1 Input 9.2 Transfer characteristics 9.3 Output characteristics 9.4 Noise and surge suppression 9.5 Battery and charger 9.6 Environment 9.7 Physical 9.8 Approvals 9.9 Typical run time versus load Note: Run times are typical at 25C (77F). Page DECLARATION OF CONFORMITY Limited Warranty Life support policy