APC SMX2200RMHV2U, SMX3000RMJ2U, SMX3000RMHV2U, SMX3000RMLV2UNC Network Management Card Settings

Function	Factory Default	Options	Description
Turn Off Delay	90 sec	Set the value in	The amount of time that the Switched Outlet
		seconds	Groups will wait between receiving the command
			to turn off and the actual shut down.
Reboot Duration	8 sec	Set the value in	The amount of time that the Switched Outlet
		seconds	Groups must remain off before it will restart.
Minimum Return	0 sec	Set the value in	The amount of battery runtime that must be
Time		seconds	available before the Switched Outlet Groups will
			turn on again after a shutdown.
Load Shed On	Disabled	• Shutdown with	When the unit switches to battery power, the UPS
Battery		Delay	can disconnect power to the Switched Outlet
		• Shutdown	Groups to save runtime.
		immediately	Configure this delay time, use the LOAD SHED
		• Turn off
		immediately	TIME WHEN ON BATTERY setting.

•Turn off with delay

•Disabled

Load Shed Time	Disabled	Set the value in	The amount of time the outlets will function on
when On Battery		seconds	battery power before they will turn off.
Load Shed On	Disabled	• Shutdown with	Configure this time using the LOAD SHED
Runtime		delay	RUNTIME REMAINING setting.

•Shutdown immediately

•Turn off immediately

•Turn off with delay

•Disabled

Load Shed On	Disabled	Set the value in	When the remaining runtime reaches this level,
Runtime		seconds	the Switched Outlet Groups will turn off.
Remaining
Load Shed on	Disabled	• Disabled	In the event of an overload (greater than 105%
Overload		• Enabled	output), the Switched Outlet Groups will
			immediately turn off to conserve power for
			critical loads. The Switched Outlet Groups will
			only turn on again with a manual command.

Network Management Card Settings

These settings are available only on units that have a Network Management Card (NMC).

•NMC IP Address Mode

•NMC Default Gateway

12 Smart-UPS X 2000/2200/3000 VA