ELITE SERIES USER MANUAL

DOS ENHANCEMENTS

or, if you’re stuck with a Disk II, type:

0

PROFILE will then ask for the seek speed of the drive:

ENTER SEEK SPEED (0-2) :

0)SLOW (DISK-II AND ELITE SERIES)

1)MEDIUM (ELITE SERIES ONLY)

2)FAST (ELITE TWO AND THREE)

The “?” in the example will be the “pre-loaded” answer (default) for the type of drive you specified on the previous menu. The default will be the maximum possible seek speed for the drive model specified. Now is not a good time to fiddle with seek speeds (you’ll just complicate matters), so just type:

<RETURN>

to use the default.

PROFILE will then update the configuration table displayed at the top of the screen. It should now show the correct setting for your system drive. At the bottom of the table, you will again get:

ENTER SELECTION (0-3)

1)LOAD NEW DOS IMAGE FROM DISK

2)CHANGE CURRENT DOS IMAGE SETTING

3)SAVE CURRENT DOS IMAGE TO DISK

0)TERMINATE PROFILE

Page 3—19