Applica LME9000 manual Assembly

A

B

Assembly

1.Slide receptacle supports (marked L (left) and R (right)) into grooves on the bottom tray until they lock into place (A).

2.Place both left and right flaps flat on top of the waste receptacle compartment panel.

3.Push the flaps in and up until they click into place (B).

• Attach the waste receptacle lid by inserting the push tabs into the round holes. To secure, press on positions indicated

(H).

H
Make sure lid edges are under the cover tabs (J).
9.	Install carbon filter:
•	Peel off the paper strip on the carbon filter to expose the
	adhesive.
J

C

D

4.Lift the flaps until they lock into place (C).

5.Snap each pivot of the waste receptacle compartment cover, one at a time, into notches in the receptacle supports (D).

6.Open waste receptacle compartment cover.

Important: Waste receptacle compartment cover must be opened to remove and install top housing.

	• Place filter adhesive-side down in the diamond-shaped insert
	in the center of the waste receptacle lid (K). Close the waste
	receptacle compartment cover.
	10. Fill the LitterMaid® litter box to just below the Full Line
	marked on the inside of litter tray.
	IMPORTANT: Use only premium clumping litter. Do not use
K	non-clumping litter, crystal or pearl-like litters.
	Recommended Hard Clumping Liters
	• LitterMaid® Hard Clumping Cat Litter

• World’s Best Cat Litter™

• ARM & HAMMER® Super Scoop® The Baking Soda Clumping Litter

7. Lift top housing. Angle into position bracket-end of top housing under tray ledge. Important: The tray should be on

top of the white bar in front of the top housing (E). Bring

the other end of top housing down into place. Check to be sure top housing is positioned securely on the tray.

E
	8. Insert waste receptacle:
	•	Open waste receptacle compartment cover.
	•	Insert a disposable waste receptacle into the waste
		receptacle compartment.
F	• Insert the edge of the waste receptacle in an inclined position
		and place it between the edge of the tray and the bar of the
		top housing (F).

• Press the waste receptacle down into position (G).

•There should be no gap between the unit and the waste receptacle.

G

• Fresh Step® Scoopable Premium Cat Litter

• EVER CLEAN® Premium Clumping Litter

Do not overfill the unit or it will not operate properly.

• Use the Fill Line on the LitterMaid® triple-action tool to

check that the litter is at the correct level in the center of the

unit (L).

L

The LitterMaid® Triple-Action Tool

This handy 3-way tool helps you measure:

• Level of litter (M).

M

7 8