110-791B 7/12/01 8:58 AM Page 27
Once the thermostat panel has been opened and removed from the base, turn the thermostat over and locate the DIP switches found on the circuit board according to the following drawing:
Be careful to change only the intended DIP switches per the explanation given at the beginning of this section.
After the DIP switches have been set to the desired position, carefully reassemble the
thermostat.
a) Place the cover on the base by lining up the 2 round pegs on the bottom of the cover with the half circle cutouts on the top of the base. Note that the bottom of the cover when fully open slides in behind the top
of the base. Swing the cover fully open. The cover will stay
in place.
– 25 –
